In this paper, we present a simulation study of analog circuit performance parameters for a symmetric double-gate junctionless transistor (DGJLT) using dual-material gate along with high- k spacer dielectric (DMG-SP) on both sides of the gate oxides of the device. The characteristics are demonstrated and compared with DMG DGJLT and single-material (conventional) gate (SMG) DGJLT. The DMG DGJLT presents superior transconductance (Gm), early voltage (VEA), and intrinsic gain (GmRO) compared with SMG DGJLT. The values are further improved for DMG-SP DGJLT, because high- k spacer enhances the fringing electric fields through the spacer.

This work focuses on the VLSI design aspect of high- speed maximum a posteriori (MAP) probability decoders which are intrinsic building-blocks of parallel turbo decoders. For the logarithmic-Bahl-Cocke-Jelinek-Raviv (LBCJR) algorithm used in MAP decoders, we have presented an ungrouped backward recursion technique for the computation of backward state metrics. Unlike the conventional decoder architectures, MAP decoder based on this technique can be extensively pipelined and retimed to achieve higher clock frequency. Additionally, the state metric normalization technique employed in the design of an add-compare-select-unit (ACSU) has reduced critical path delay of our decoder architecture. We have designed and implemented turbo decoders with 8 and 64 parallel MAP decoders in 90 nm CMOS technology. VLSI implementation of an 8 × parallel turbo-decoder has achieved a maximum throughput of 439 Mbps with 0.11 nJ/bit/iteration energy-efficiency. Similarly, 64 × parallel turbo-decoder has achieved a maximum throughput of 3.3 Gbps with an energy-efficiency of 0.079 nJ/bit/iteration. These high-throughput decoders meet peak data-rates of 3GPP-LTE and LTE-Advanced standards.

An efficient micro-scale solar power management architecture for self-powered Internet-of-Things node is presented in this paper. The proposed architecture avoids the linear regulator and presents a complete on-chip switched capacitor based power converter in order to achieve higher end-to-end efficiency. Unlike traditional architectures, where the harvested energy processes twice, the proposed architecture processes the harvested energy only once before it reaches to the load circuit, irrespective of the ambient conditions. The system efficiency has been improved by ~12% over the traditional architecture. The entire power management system has been designed using 0.18-μm CMOS technology node, and the circuit simulations demonstrate that the proposed architectural changes bring in a system efficiency of 82.4% under different light conditions. In addition to that, a hardware setup is created using commercially available ICs and photovoltaic cells, to validate that the proposed power management system is practically realizable.