Convective transition statistics serve as diagnostics for the parameterization of convection in climate and weather forecast models by characterizing the dependence of convection on the humidity-temperature environment. The observed strong pickup of precipitation as a function of layer-averaged water vapor and temperature is captured in models with varying accuracy. For independent observational verification, a low-Earth orbiting satellite constellation of Global Navigation Satellite System (GNSS) polarimetric radio occultation (PRO) measurements would be spaced such that adjacent RO would capture different profiles within and immediately adjacent to convection. Here, the number of profile observations needed to distinguish between convective transition relations by different tropospheric temperature ranges is determined, over different tropical oceanic basins. To obtain these, orbit simulations were performed by flying different satellite constellations over global precipitation from the Global Precipitation Measurement (GPM) mission, varying the numbers of satellites, orbit altitude, and inclination. A 45-degree orbit inclination was found to be a good tradeoff between maximizing the number of observations collected per day, and the desired 50–150-km spacing between individual RO ray paths. Assuming a set of reasonable assumptions for net data yield, three tropospheric temperatures can be distinguished by 1 K with a six-month on-orbit duration from a constellation of at least three satellites.
[1] Site test interferometers (STIs) have been deployed at two locations within the NASA Deep Space Network tracking complex in Goldstone, California. An STI measures the difference of atmospheric delay fluctuations over a distance comparable to the separations of microwave antennas that could be combined as phased arrays for communication and navigation. The purpose of the Goldstone STIs is to assess the suitability of Goldstone as an uplink array site and to statistically characterize atmosphere-induced phase delay fluctuations for application to future arrays. Each instrument consists of two ~1 m diameter antennas and associated electronics separated by ~200 m. The antennas continuously observe signals emitted by geostationary satellites and produce measurements of the phase difference between the received signals. The two locations at Goldstone are separated by 12.5 km and differ in elevation by 119 m. We find that their delay fluctuations are statistically similar but do not appear as shifted versions of each other, suggesting that the length scale for evolution of the turbulence pattern is shorter than the separation between instruments. We also find that the fluctuations are slightly weaker at the higher altitude site.
1 January 1999 in IEEE Antennas and Propagation Magazine
NASA's mars reconnaissance orbiter (MRO) was launched on August 12, 2005 and was inserted into Mars orbit successfully on March 10, 2006. From September 2005 through January 2006, the Ka-band signal from the spacecraft was tracked several times by NASA's deep space network (DSN). During these tracks a number of Ka-band functions for both the spacecraft and the ground systems were tested. These tests were performed to assess the readiness of the ground system and spacecraft to support Ka-band demonstration activities during MRO's primary science phase (PSP). As a result of these tests a number of important lessons were learned regarding the performance of the Ka-band link and the performance of the ground equipment. This paper presents the performance of the ground antenna pointing, delta differential one-way ranging (DeltaDOR) performance and the telemetry performance of the Ka-band link. These results indicate that the extra effort for pointing calibration of the ground antennas at Ka-band is extremely useful; Ka-band shows potential for improved DeltaDOR performance and the models for Ka-band performance of the ground station microwave noise temperature are very accurate.