The effects of biochar on different horticultural crops (lettuce, tomato, sweet pepper, and radish) were evaluated in the Mediterranean climate. Biochar was produced by pyrolysis of Pinus pinaster wood chips at 550 °C and used at 1 (B1) and 2 (B2) kg/m² application rates on six 3.5 m² plots in each treatment, with two control plots (B0). No fertilizer was used. Treatment B1 led to a significant increase (p < 0.01) of 35.4%, 98.1%, 28.4%, and 35.2% in the mean fresh weight of radishes, lettuce, tomatoes, and sweet peppers, respectively. Treatment B2 resulted in an improvement of 70.7% in radishes, 126.1% in lettuce, 38.4% in tomatoes, and 95.0% in sweet peppers (p < 0.01). Significant differences between treatments B1 and B2 were observed in the radish, tomato, and sweet pepper crops but not in lettuce. The profitability of biochar application to these crops was studied by considering a biochar price of 800 EUR/t and applying a CO₂ fixation subsidy, assuming the updated February 2022 price (90 EUR/t). In lettuce, tomato, and sweet pepper crops, the investment payback period was approximately one year. Application of biochar generated economic benefit either from the first harvest or in the second year. In radish, this period was longer than two years; however, an increase in the annual frequency of cultivation should be studied to optimize the benefit. The dose that provided the greatest benefit was B1 (for all crops, except for sweet pepper). Biochar considerably improved fruit and vegetable yield under the Mediterranean climate; however, further studies are needed to assess the effects of biochar on soil properties and yield to estimate long-term environmental and economic benefits.

The effects of two types of biochar on corn production in the Mediterranean climate during the growing season were analyzed. The two types of biochar were obtained from pyrolysis of Pinus pinaster. B1 was fully pyrolyzed with 55.90% organic carbon, and B2 was medium pyrolyzed with 23.50% organic carbon. B1 and B2 were supplemented in the soil of 20 plots (1 m²) at a dose of 4 kg/m². C1 and C2 (10 plots each) served as control plots. The plots were automatically irrigated and fertilizer was not applied. The B1-supplemented plots exhibited a significant 84.58% increase in dry corn production per square meter and a 93.16% increase in corn wet weight (p << 0.001). Corn production was no different between B2-supplemented, C1, and C2 plots (p > 0.01). The weight of cobs from B1-supplemented plots was 62.3%, which was significantly higher than that of cobs from C1 and C2 plots (p < 0.01). The grain weight increased significantly by 23% in B1-supplemented plots (p < 0.01) and there were no differences between B2-supplemented, C1, and C2 plots. At the end of the treatment, the soil of the B1-supplemented plots exhibited increased levels of sulfate, nitrate, magnesium, conductivity, and saturation percentage. Based on these results, the economic sustainability of this application in agriculture was studied at a standard price of €190 per ton of biochar. Amortization of this investment can be achieved in 5.52 years according to this cost. Considering the fertilizer cost savings of 50% and the water cost savings of 25%, the amortization can be achieved in 4.15 years. If the price of biochar could be reduced through the CO₂ emission market at €30 per ton of non-emitted CO₂, the amortization can be achieved in 2.80 years. Biochar markedly improves corn production in the Mediterranean climate. However, the amortization time must be further reduced, and enhanced production must be guaranteed over the years with long term field trials so that the product is marketable or other high value-added crops must be identified.

In this work, chemical recycling as an alternative to conventional end-of-life treatments was studied. Two different types of end-of-life tires (ELT), truck tires and mix tires (50:50 mixture of passenger car and truck tires), were pyrolyzed in a batch microwave reactor. The influence of specific power (10, 20, and 30 W/g) on mass distribution was analyzed. The maximum liquid yield was attained at 10 W/g, while the maximum gas yield is obtained at 30 W/g. Liquid fractions were characterized by gas chromatography/quadrupole mass spectrometry (GC/qMS) to identify the main components, and major compounds were quantified. In all samples, limonene (3.76 ± 0.31–6.80 ± 2.37 wt. %) and BTEX (3.83 ± 0.20–1.19 ± 2.80 wt. %) were the main components. Major limonene concentration is obtained in oil produced from truck ELT while higher yields of aromatic compounds are obtained from mix ELT. The maximum BTEX concentration is obtained at 10 W/g being toluene the main compound with a concentration of 2.07 ± 0.42 and 4.63 ± 1.29 for truck and mix ELT, respectively. The separation and purification of these compounds will confer important value to these fractions. Higher yields of the solid fraction are produced when mix tires are pyrolyzed due to the higher concentration of ash in this type of ELT. Recovered carbon black was characterized by measuring the surface area.