Bella B. Zviagina

Dr. Bella B. Zviagina

orcid

Research Focus & Metrics

Academic Career Length

34Years (1993-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2010 in American Mineralogist: Journal of Earth and Planetary Materials
Verified
Journal Article
Closed access
PDF file
VDVictor A. Drits
Victor A. Drits
BZBella B. Zviagina
Bella B. Zviagina
DMDouglas K. McCarty
Douglas K. McCarty
ASAlfred L. Salyn
Alfred L. Salyn
Several finely dispersed low-temperature dioctahedral micas and micaceous minerals that form solid solutions from (Mg, Fe)-free illite to aluminoceladonite via Mg-rich illite, and from Fe3+-rich glauconite to celadonite have been studied by X-ray diffraction and chemical analysis. The samples have 1M and 1Md structures. The transitions from illite to aluminoceladonite and from glauconite to celadonite are accompanied by a consistent decrease in the mica structural-unit thickness (2:1 layer + interlayer) or csinβ. In the first sample series csinβ decreases from 10.024 to 9.898 Å, and in the second from 10.002 to 9.961 Å. To reveal the basic factors responsible for these regularities, structural modeling was carried out to deduce atomic coordinates for 1M dioctahedral mica based on the unit-cell parameters and cation composition. For each sample series, the relationships among csinβ, maximum and mean thicknesses of octahedral and tetrahedral sheets and of the 2:1 layer, interlayer distance, and variations of the tetrahedral rotation angle, α, and the degree of basal surface corrugation, ΔZ, have been analyzed in detail. The transitions from illite to aluminoceladonite and from glauconite to celadonite are accompanied by a slight increase in the mean thickness of the 2:1 layers and a steady decrease in the α angles, whereas the interlayer distance becomes smaller. These results are consistent with the generally accepted model where tetrahedral rotation is the main factor for the interlayer contraction in muscovite-phengite structures: the smaller the rotation angle (α) the larger the ditrigonal ring of the tetrahedral sheet and the interlayer pseudo-hexagonal cavity, allowing the interlayer cation to sink and thus shorten the c parameter. A new insight into the interpretation of the contraction of the mica layer thickness in dioctahedral micas has been achieved with the discovery that micas with the same or close mean interlayer distance, on one hand, have the same or nearly the same substitution of Al for Si; and on the other hand, they may have significantly different parameters of the interlayer structure, such as tetrahedral rotation, basal surface corrugation, ΔZ, and minimum and maximum interlayer distance. These results show that in dioctahedral 1M micas, the mean interlayer distance is determined by the amount of tetrahedral Al because the higher the Al for Si substitution, the stronger the repulsion between the basal O atoms and the larger the interlayer distance and csinβ parameter.

1 August 2004 in Clays and Clay Minerals
Verified
Journal Article
Closed access
BZBella B. Zviagina
Bella B. Zviagina
DMDouglas K. McCarty
Douglas K. McCarty
JŚJan Środoń
Jan Środoń
VDVictor A. Drits
Victor A. Drits
Dioctahedral smectite samples of a wide range of compositions (beidellites, montmorillonites, nontronites, Fe-rich montmorillonites and Al-rich nontronites) were studied by infrared (IR) spectroscopy. A special sample-preparation technique was used to eliminate the contribution of molecular water. The OH-stretching regions of the spectra were decomposed and curve-fitted, and the individual OH-stretching bands were assigned to all the possible types of OH-bonded cation pairs that involve Al, Mg and Fe. The integrated optical densities of the OH bands were assumed to be proportional to the contents of the specific types of OH-linked cation pairs with the absorption coefficients being the same for all individual OH bands. Good agreement between the samples’ octahedral cation compositions calculated from the IR data and those given by crystal-chemical formulae was obtained for a representative collection of samples in terms of a unique set of individual OH-band positions that vary within narrow wavenumber intervals. This has allowed us to minimize the ambiguity in spectra decomposition caused by the poor resolution of smectite spectra and confirmed the validity of the resulting band identification.The bands associated with specific OH-bonded cation pairs in the spectra of smectites are, on the whole, shifted to greater wavenumbers with respect to the corresponding bands in micas. In addition to OH bands that refer to the smectite structure, AlOHAl and AlOHFe bands of the pyrophyllite structural fragments were identified. The band-position variation ranges overlap in a few cases (AlOHFe and MgOHMg; AlOHAl of smectite and AlOHFe of pyrophyllite-like component).Unambiguous interpretation of the OH-stretching vibrations was found to be possible only for smectite samples with known chemical compositions, so that IR data cannot be used for quantitative determination of octahedral cation composition of mixtures of dioctahedral 2:1 phyllosilicates. In the case of the studied monomineral smectites with known chemical compositions, IR data provided information on the short-range order/disorder in the distribution of octahedral cations along cation-OH-cation directions. This information can be employed, in conjunction with the data of other spectroscopic and diffraction techniques, in the analysis of short-range octahedral cation distribution.

11 February 2020 in Minerals
Verified
Journal Article
Open access
PDF file
BZBella B. Zviagina
Bella B. Zviagina
VDVictor A. Drits
Victor A. Drits
ODOlga Dorzhieva
Olga Dorzhieva
A representative collection of K-dioctahedral 1M micas ranging in composition from (Mg, Fe)-poor illites to aluminoceladonites through Mg-rich illites (Fe-poor varieties) and from Fe-bearing, Mg-rich illites to celadonites through Fe-illites, Al-glauconites and glauconites (Fe-bearing varieties) was studied by Fourier-transform infrared (FTIR) spectroscopy in the middle-infrared region. Analysis and comparison of the relationships between the band positions and cation compositions of Fe-poor and Fe-bearing K-dioctahedral micas provided a generalized set of FTIR identification criteria that include the band positions and profiles in the regions of Si–O bending, Si–O stretching, and OH-stretching vibrations. FTIR data allow unambiguous identification of illites, aluminoceladonites, and celadonites, as well as distinction between Fe-illites and illites proper, as well as between Al-glauconites and glauconites. Specifically, a sharp maximum from the AlOHMg stretching vibration at ~3600 cm−1, the presence of a MgOHMg stretching vibration at 3583–3585 cm−1, as well as characteristic band positions in the Si–O bending (435–439, 468–472 and 509–520 cm−1) and stretching regions (985–1012 and 1090–1112 cm−1) are clearly indicative of aluminoceladonite. The distinction between Fe-illites and Al-glauconites, which have similar FTIR features, requires data on cation composition and unit-cell parameters.

1 April 2006 in Clays and Clay Minerals
Verified
Journal Article
Closed access
VDVictor A. Drits
Victor A. Drits
DMDouglas K. McCarty
Douglas K. McCarty
BZBella B. Zviagina
Bella B. Zviagina
Crystal chemical analysis of various dioctahedral 2:1 phyllosilicates consisting of trans-vacant (tv) and cis-vacant (cv) layers and interstratified cv and tv layers shows that there is compositional control over the distribution of octahedral cations over trans and cis sites. Fe3+ and Mg-rich dioctahedral micas (celadonite, glauconite, leucophyllite and most phengite) occur only as tv varieties. Similarly, the occurrence of tv illites and tv illite fundamental particles in illite-smectite (I-S) does not depend significantly on the cation composition of the 2:1 layers. In contrast, compositional restrictions exist to control the occurrence of pure cv1M illite, which can form only as Fe- and Mg-poor varieties. Similarly, proportions of cv and tv layers in illite fundamental particles depend on the amount of Al in octahedral and tetrahedral sheets of the 2:1 layers.Simulations of atomic coordinates and interatomic distances for periodic tv1M and cv1M illite structures allow us to reveal the main structural factors that favor the formation of cv layers in illite and I-S. It is shown that in contrast to the tv1M structure, interlayer K in cv1M illite has an environment which is similar to that in 2M1 muscovite. This similarity along with a high octahedral and tetrahedral Al content probably provides stability for cv1M illite in low-temperature natural environments. Because of structural control, the occurrence of monomineral cv1M illite, its association with tv 1M illite, and interstratified cv-tv illite fundamental particles is confined by certain physical and chemical conditions. These varieties are most often formed by hydrothermal activity of different origin. The initial material for their formation should be Al-rich and the hydrothermal fluids should be Mg- and Fe-poor. They occur mostly around ore deposits, in bentonites and in sandstone sedimentary rocks.The factors governing the formation of tv and cv layers in dioctahedral smectite are probably related to the layer composition and local order-disorder in the distribution of isomorphous octahedral cations, because there is no influence from fixed interlayer cations. In particular, the occurrence of Mg-OH-Mg cation arrangements is more favorable for the formation of cv montmorillonite layers.

1 August 2009 in Clays and Clay Minerals
Verified
Journal Article
Closed access
VDVictor A. Drits
Victor A. Drits
BZBella B. Zviagina
Bella B. Zviagina
A comprehensive study of clay minerals should include determination of the vacancy pattern of the dioctahedral sheet. The purpose of this report is to consider the advantages and limitations in various diffraction and non-diffraction methods for the determination of the layer types in clay minerals. Identification of trans-vacant (tv) and cis-vacant (cv) clay minerals reported here is based on powder X-ray diffraction (XRD) patterns calculated for different polytypes consisting of either tv or cv layers, on the simulation of experimental XRD patterns corresponding to illite or illite fundamental particles in which tv and cv layers are interstratified, and on the semi-quantitative assessment of the relative content of the layer types in the interstratified structures by generalized Méring’s rules. A simple and effective method for identification of tv and cv layers in dioctahedral 2:1 layer silicates employs thermal analysis and is based on different dehydroxylation temperatures for tv and cv illite and smectite layers.Crystal chemical analysis of various dioctahedral 2:1 layer silicates consisting of tv and cv layers indicates that compositional control is present in the distribution of octahedral cations over trans- and cis-sites. In dioctahedral smectites the formation of tv and cv layers is related to the layer composition and local order-disorder in the distribution of isomorphous cations. Dioctahedral 1M micas with abundant Fe3+ and Mg occur only as tv varieties. In contrast, 1M-cv illite, as well as cv layers in illite fundamental particles of I-S, can form only as Fe- and Mg-poor varieties. In illites and illite fundamental particles of I-S consisting of tv and cv layers, cv layers prevail when the amounts of Al in octahedra and tetrahedra are >1.55 and >0.35 atoms per O10(OH)2, respectively.The main factors responsible for the stability of cv and tv illites have been established. Monomineral cv 1M illite, its association with tv 1M illite, and interstratified cv/tv illite occur around ore deposits, in bentonites, and in sandstones mostly as a result of different types of hydrothermal activity. The initial material for their formation should be Al-rich, and hydrothermal fluids should be Mg- and Fe-poor.Tv and cv smectites of volcanic origin differ in terms of octahedral cation composition and distribution of isomorphous octahedral cations. Mg-rich cv smectites have random distribution of isomorphous octahedral cations, whereas in Mg-bearing tv smectites octahedral Mg cations are dispersed so as to minimize the amount of Mg-OH-Mg arrangements.

1 December 2004 in Clay Minerals
Verified
Journal Article
Closed access
VDV. A. Drits
V. A. Drits
HLH. Lindgreen
H. Lindgreen
BSB. A. Sakharov
B. A. Sakharov
HJH. J. Jakobsen
H. J. Jakobsen
BZBella B. Zviagina
Bella B. Zviagina
The structure of an illite-smectite (I-S) sample (HSI) from the Tertiary–Cretaceous boundary layer at Stevns, Denmark, i.e. the so-called Fish Clay, is investigated in order to discuss the origin of this clay and its similarity to clays from Maastrichtian-Danian chalk of Denmark and the North Sea. The phase compositions and layer sequences have been determined by X-ray diffraction. The structural formulae are determined from chemical analysis and solid-state 27Al magic-angle spinning (MAS) nuclear magnetic resonance (NMR) spectroscopy. The octahedral vacancy pattern has been determined by thermal analysis and the particle shape by atomic force microscopy. The HSI sample I-S consists of two phases, a high-smectitic (HS) phase (70%) having 95% smectite and 5% illite (leucophyllite) layers, and a low-smectitic (LS) phase (30%) having 50% smectite and 50% illite (leucophyllite) layers. Both phases have trans-vacant dioctahedral sheets and contain only traces of IVAl, the charge of the illite (leucophyllite) layers being provided predominantly by octahedral Mg for Al substitution. The structure of the tetrahedral and octahedral sheets for the HSI are compared to the structure of an I-S sample (GRI) from the Maastrichtian chalk at Stevns below the Tertiary-Cretaceous boundary and to the standard smectite SAz-1 from Arizona. For all three samples the 27Al MAS NMR spectra show the presence of two resolved IVAl resonances, which indicate the presence of two different IVAl sites. The NMR, infrared spectroscopy and chemical data show that both HSI and GRI have highly ordered Mg for Al substitution in the octahedral sheet, each Al having one Mg and two Al neighbours, whereas substitution of Mg for Al in SAz-1 is random. For the HSI sample, both the HS and LS phases are probably formed from volcanic ash. The structural similarity of the phases in HSI and GRI shows that GRI formed from a material similar to HSI by illitization of the HS phase and chloritization of the LS phase.