One of the parameters that directly affects the seismic demand on a bridge is the excitation angle of the ground motion. Since analyzing a bridge with all possible excitation angles is impractical, combination rules have been used for computation of seismic demands. Provisions and specifications recommend the use of combination rules for computation of displacements and elastic forces, but they do not clearly suggest any combination rules for nonlinear time history analysis of bridges. This paper evaluates the 100/30, 100/40, and SRSS combination rules for nonlinear time history analysis of bridges. The probability of underestimation is computed for each combination rule, assuming a uniform distribution for the excitation angle. Two cases are considered for the combination rules: In the first case, only the major components of the earthquake records are used; the second case consists of using paired acceleration time histories. Results show that in the first case, the probability of underestimation is mor...
1 February 2023 in Journal of Composites for Construction
Externally bonded carbon fiber–reinforced polymer (CFRP) composites have been instrumental in the flexural strengthening of concrete structures. However, intermediate crack debonding from the concrete substrate is a governing failure mode in most externally bonded CFRP applications, limiting the composite strength utilization and deformability of a strengthened member. The addition of transverse U-wrap anchorage for longitudinally oriented CFRP sheet tension reinforcement can improve performance in terms of both deformability and ultimate strength. Due to the scarcity of experimental data, design guidance for U-wrap anchorage to mitigate intermediate crack debonding is lacking. The results of flexural tests on large-scale reinforced concrete beams strengthened in flexure with externally bonded CFRP anchored with U-wraps are reported in this paper. Test results indicate that U-wraps can increase the strain utilization of longitudinal CFRP between 40% and 57%, while also mitigating the intermediate crack debonding failure mode. Varying the ratio of the area of U-wrap anchorage to area of flexural CFRP had little effect on the beams’ flexural capacity.
The paper proposes a new approach for optimal design structures equipped with tuned mass dampers (TMDs) with large mass ratios. The approach is based on minimizing the frequency response function (FRF) of displacement response of the structure as well as the acceleration of the TMD that leads to almost equal modal damping ratios in the first and second mode of vibration. Furthermore, two regression equations are proposed to predict the optimum TMD properties. It is concluded that choosing the optimum TMD parameters as suggested in this study provides up to 94% reduction in the maximum FRF of structural displacement.
1 November 2022 in Practice Periodical on Structural Design and Construction
Structural evaluations are important for monitoring performance and behavior changes that occur due to environmental or other loading conditions. As a renowned experimental mechanics technique, digital image correlation (DIC) has become a widely accepted tool for obtaining not only qualitative, but quantitative structural engineering measurements. In this review, the principles of DIC for displacement field measurements are presented through structural evaluation illustrations. Several developing studies of the method in combination with other techniques for novel assessment approaches are also discussed. The method has grown immensely from conception, and its significance for paving the way to infrastructure resiliency framework is further highlighted. Ongoing DIC measurement challenges can also be reviewed in addition to leading initiatives for addressing future needs in evaluating the structural infrastructure. Overall, this review promotes the flexibility of DIC for implementation as a fully deployable structural evaluation method with great sustainable implications.
Choosing the direction of applied earthquake forces has always been an important issue in earthquake engineering, especially as it refers to nonlinear analysis. Determination of the response to all possible incident angles is too time consuming and not practical. Fortunately, in recent years, some studies have been conducted on the response spectrum method of analysis of structures subjected to multicomponent earthquake excitation that enables the designer to find the most critical angle of excitation. However, the results from these studies are only valid for the response spectrum method for a linear elastic analysis. As such, there is no method to find the critical angle of excitation for a nonlinear time history analysis. This paper investigates the orthogonal effects in nonlinear analysis of candidate single-span bridges subjected to multicomponent earthquake excitations, and evaluates the effects of nonlinearities in candidate bridges affected by varying angles of excitation to determine the most critical angle. Also a comparison will be made between the results of the multicomponent earthquake excitations and AASHTO combination rule for combining the effects of separate unidirectional excitations. Although seismic analysis is not necessary for single-span bridges based on AASHTO, this paper applies AASHTO procedure on single-span bridges to compare the procedure to the results of nonlinear time history analyses (NTHA) at various excitation angles. Results show that the critical excitation angle is not the same in linear and nonlinear models and nonlinear models are more sensitive to the angle of excitation. It is also concluded that AASHTO procedure may underestimate the maximum probable response.