This paper systematically explains the methodology and results of empirical work on the development of a low-cost filament winding technology for manufacturing axisymmetric polymer composite structures with a high length-to-diameter ratio, such as tubes, motor casings, and pressure vessels. The principal objective was to examine the experiences and most optimal practices in the development of computer-controlled equipment and auxiliary tooling for the wet filament-winding process. To preclude expensive commercial software for the automated control of a winding machine, analytical equations were derived for the winding trajectory of a four-axis filament-winding machine. The feasibility of the proposed equations was successfully validated by laying the fiber along the geodesic path marked on the surface of a cylindrical mandrel with hemispherical ends. Moreover, the carbon/epoxy cylindrical casings with hemispherical ends and port openings of the same diameter were wound to determine the thickness distribution in the hemispherical dome. The fiber volume ratio in the wound composite parts was evaluated using an optical technique.
The objective of this study was to characterize the thermal insulation efficiency of the silicone rubber reinforced composites by oxyacetylene torch. These composites reinforced by glass, carbon, ceramics and silica fibers were intended to be used as ablators in a low-thrust hybrid propulsion motor. The back-face temperature measurements were used as a criterion for insulation efficiency of the specimens, whose frontal face is subjected to the oxyacetylene flame for 40 s. The paper includes the results of the ablation rate measurements and the influence of orientation of glass and carbon fibers relatively to the flame direction on the back-face temperature of the specimens.
4 May 2023 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
This paper presents a simplified computation approach for the machine path (or winding trajectory) of grid structures and tubes with a circular cross-section and angle-ply or double-double layup. The solution for the machine path is given through controllable degrees of freedom of a low-cost two-axis filament winding machine (FWM): mandrel rotation and translation of the delivery eye along the axis of the mandrel. The efficiency of the analytical solution for the machine path of the FWM was ascertained by automated laying the cotton thread over the geodesic and non-geodesic groove imprinted on the surface of a cylindrical polylactide mandrel. These results validated the possibility of manufacturing cylindrical composite structures with an angle-ply layup or double-double stacking sequence, without the need for expensive software, making the winding technology accessible to society and promoting university extension.
The study relates to the filament winding of a flexible conical aeroshell that belongs to the deployable thermal protection system for the controlled re-entry and safe recovery of CubeSat class satellites. A review of the flexible thermal protection systems made it possible to allocate materials for deployable mechanisms into a separate group by highlighting their principal features. Following the review, the filament winding of conical structures does not pose significant difficulties, except for the limitations in the available fiber paths and lack of data on the tow tension fluctuations during the manufacturing process. In the study, the available fiber paths for two configurations of the conical aeroshell were compared with the principal stress distributions expected during the operation of the flexible thermal protection system. The stress distributions have been evaluated by several theories related to the bending of thin plates or membranes under transverse load. It was shown that the stress distributions did not agree with the stiffness distribution of the filament wound structure, which was computed by the methods adopted in the classic lamination theory. The effect of various machine paths on the tow tension fluctuations was studied experimentally for the conical structures with the help of a laboratory 4-axis filament winding machine. The analytically computed machine path, which does not require a mechanism to rewind the tow over the packages during the winding process, was used to manufacture a small-scale flexible aeroshell. The features of the wound flexible aeroshell were discussed in conclusion.