Numerical simulations were conducted to study the melt flow under the influence of control devices in a T-type two-strand bloom caster tundish via the open source Computational Fluid Dynamics software OpenFOAM. Three different cases were studied: a bare tundish, a tundish with two pairs of baffles, and a tundish equipped with a turbulence inhibitor and a pair of baffles. Turbulence inhibitor and baffles arrangement showed an improvement of the fluid flow characteristics, yielding lower values of dead volume and higher values of plug flow. With a turbulence inhibitor, the velocity of metal which flows directly toward the tundish floor is smaller and the turbulence kinetic energy of the melt top surface is lower than the other two arrangements.
1 January 2007 in International Journal of Nonlinear Sciences and Numerical Simulation
Soot generally refers to carbonaceous particles formed during incomplete combustion of hydrocarbon fuels. A typical simulation of soot formation and evolution contains two parts: gas chemical kinetics, which models the chemical reaction from hydrocarbon fuels to soot precursors, that is, polycyclic aromatic hydrocarbons or PAHs, and soot dynamics, which models the soot formation from PAHs and evolution due to gas-soot and soot-soot interactions. In this study, two detailed gas kinetic mechanisms (ABF and KM2) have been compared during the simulation (using the solver Chemkin II) of ethylene combustion in counterflow diffusion flames. Subsequently, the operator splitting Monte Carlo method is used to simulate the soot dynamics. Both the simulated data from the two mechanisms for gas and soot particles are compared with experimental data available in the literature. It is found that both mechanisms predict similar profiles for the gas temperature and velocity, agreeing well with measurements. However, KM2 mechanism provides much closer prediction compared to measurements for soot gas precursors. Furthermore, KM2 also shows much better predictions for soot number density and volume fraction than ABF. The effect of nozzle exit velocity on soot dynamics has also been investigated. Higher nozzle exit velocity renders shorter residence time for soot particles, which reduces the soot number density and volume fraction accordingly.
23 September 2016 in Applied Mathematics and Mechanics
Particle resolved direct numerical simulation (PR-DNS) is one of the most powerful research tools for particle laden flows. Among a few most popular PR-DNS methods, the direct forcing immersed boundary method (DF-IBM) has obtained great success and has been adopted in various simulations of rigid particulate flows. Within DF-IBM, Eulerian and Lagrangian frameworks are used to depict the continuum and dispersed phases, respectively. Interpolation between the two frameworks is accomplished through a discrete delta function. It is generally believed that a Lagrangian weight attached to each Lagrangian marker, which is distributed on a particle’s surface, needs to be carefully chosen. To be more specific, the Lagrangian weight is supposed to match the local Eulerian cell. The matching requirement is not trivial for non-uniform Eulerian mesh or irregular shaped particles. There are various methods developed to calculate the Lagrangian weight. Here, the Lagrangian weights in a few testing cases have been calculated following two intuitively “straightforward” methods. It turns out there are substantial discrepancies in the Lagrangian weights obtained from different methods. However, further numerical examples demonstrate that such discrepancies have negligible effects on the flow dynamics. So a natural question is raised: Is Lagrangian weight crucial in the direct forcing immersed boundary method? A negative answer to this question is suggested. More detailed analysis is provided in a forthcoming paper.