Zinc oxynitride semiconductor material is produced through a reactive sputtering process in which competition between reactions responsible for the growth of hexagonal zinc oxide (ZnO) and for the growth of cubic zinc nitride is promoted. In contrast to processes in which the reaction for either the oxide or the nitride is dominant, the multireaction process yields a substantially amorphous or a highly disordered nanocrystalline film with higher Hall mobility, for the as-deposited film produced at and after annealing at . In addition, it has been observed that the Hall mobility of the material increases as the carrier concentration decreases in a carrier concentration range where a multicomponent metal oxide semiconductor, indium–gallium–zinc oxide, follows the opposite trend. This indicates that the carrier transports in the single-metal compound and the multimetal compound are probably dominated by different mechanisms. Film stability and thin film transistor performance of the material have also been tested, and results are presented herein.
The density of localized tail states in amorphous ZnON (a-ZnON) thin film transistors (TFTs) is deduced from the measured current-voltage characteristics. The extracted values of tail state density at the conduction band minima (Ntc) and its characteristic energy (kTt) are about 2 × 1020 cm−3eV−1 and 29 meV, respectively, suggesting trap-limited conduction prevails at room temperature. Based on trap-limited conduction theory where these tail state parameters are considered, electron mobility is accurately retrieved using a self-consistent extraction method along with the scaling factor ‘1/(α + 1)’ associated with trapping events at the localized tail states. Additionally, it is found that defects, e.g. oxygen and/or nitrogen vacancies, can be ionized under illumination with hv ≫ Eg, leading to very mild persistent photoconductivity (PPC) in a-ZnON TFTs.
A sensitive method for detecting particle deposition on semiconductor wafers has been developed. The method consisted of generating a monodisperse fluorescent aerosol, depositing the known-size monodisperse aerosol on a wafer in a laminar flow chamber, and analyzing the deposited particles using a fluorometric technique. For aerosol particles in the size range of 0.1–1.0 μm, the mobility classification-inertial impaction technique developed by Romay-Novas and Pui (1988) was used to generate the monodisperse test aerosols. Above a particle diameter of 1.0 μm, monodisperse uranine-tagged oleic acid aerosols were generated by a vibrating-orifice generator. The test wafer was a 3.8-cm diameter silicon wafer placed horizontally in a vertical laminar flow chamber which was maintained at a free stream velocity of 20 cm/s. A condensation nucleus counter and an optical particle counter were used to obtain the particle concentration profile in the test cross section and to monitor the stability of aerosol concentration during the experiment. The results show that the measured particle deposition velocities on the wafers agree well with the theory of Liu and Ahn (1987) in the particle size range between 0.15 and 8.0 μm. The deposition velocity shows a minimum around 0.25 μm in particle diameter and increases with both smaller and larger particle size owing to diffusional deposition and gravitational settling, respectively.
Transmission measurements have been performed on University Research Glassware, Inc. model 2000–30B glass annular denuders at 10 L/min using monodisperse particles in the 0.01–1-μm diameter size range. Through control of the aerosol charge state, particle losses due to diffusion and electrostatic effects were separately measured and theoretical descriptions of both were developed. For Boltzmann charged (atmospheric) particles in the important 0.1–1-μm diameter size range total losses averaged only a few percent or less. Particle transmission measurements also confirmed the design value of 2.5 μm for the 50% cutpoint diameter of the URG 2000-30EN cyclone inlet used with these annular denuders.