Results from large-eddy simulations of a classical hydraulic jump at inlet Froude number two are reported. The computations were performed using the general-purpose finite-volume-based code OpenFOAM®, and the primary goal was to evaluate the influence of the modelling parameters on the predictive accuracy, as well as establish the associated best-practice guidelines. A benchmark simulation was conducted on a grid with a 1 mm-cell-edge length to validate the solver and provide a reference solution for the parameter influence study. The remaining simulations covered different selections of the modelling parameters: geometric vs. algebraic interface capturing, three mesh resolution levels, and four choices of the convective flux interpolation scheme. Geometric interface capturing led to better accuracy, but deteriorated the numerical stability and increased the simulation times. Interestingly, numerical dissipation was shown to systematically improve the results, both in terms of accuracy and stability. Strong sensitivity to the grid resolution was observed directly downstream of the toe of the jump.
1 January 2019 in Engineering Applications of Computational Fluid Mechanics
Two cases are presented wherein the main flow pattern in sand traps changes considerably as a function of discretization scheme, grid resolution and turbulence model. Both cases involve channel flows directed into a desilting basin, where the main current changes from one part of the geometry to the other. The CFD computations are validated with field or laboratory measurements. The first case presented is one of the sand traps of Khimti hydro power plant in Nepal. According to the laboratory measurements, the recirculation zone for this case is close to the bed, with the main current following the water surface. This is reproduced by the numerical model when using a first-order upwind scheme. Using a second-order upwind scheme, the main current is close to the bed, and the recirculation is formed at the surface. The second case is one of the sand traps of Tonstad hydro power plant in Norway. CFD computations predict the main flow field to follow the right or the left sides or the centre of the expansion region, depending on the discretization scheme, grid resolution and turbulence model. Field measurements show that the main current follows the centre of the expansion zone.
Results from large-eddy simulations of a classical hydraulic jump at inlet Froude number 2 are reported. The computations are performed using the general-purpose finite-volume based code OpenFOAM, and the primary goal is to evaluate the influence of modelling parameters on the predictive accuracy, as well as establish associated best-practice guidelines. A benchmark simulation on a dense computational mesh is conducted, and good agreement with existing reference data is found. The remaining simulations cover different selections of modelling parameters: geometric vs algebraic interface capturing, three mesh resolution levels, four choices of the convective flux interpolation scheme. Geometric interface capturing leads to better accuracy but deteriorated numerical stability and increased simulation times. Interestingly, numerical dissipation is shown to systematically improve the results, both in terms of accuracy and stability. The densest of the three grids, which is twice as coarse as the grid used in the benchmark simulation, was found to be sufficient for faithfully reproducing all the considered quantities of interest. The recommendation is therefore to use this grid, geometric interface capturing, and a second-order upwind scheme for the convective fluxes.