Producing lightweight structures with high weight-specific strength and stiffness, self-healing abilities, and recyclability, is highly attractive for engineering applications such as aerospace, biomedical devices, and smart robots. Most self-healing polymer systems used to date for mechanical components lack 3D printability and satisfactory load-bearing capacity. Here, we report a new self-healable polymer composite for Digital Light Processing 3D Printing, by combining two monomers with distinct mechanical characteristics. It shows a desirable and superior combination of properties among 3D printable self-healing polymers, with tensile strength and elastic modulus up to 49 MPa and 810 MPa, respectively. Benefiting from dual dynamic bonds between the linear chains, a healing efficiency of above 80% is achieved after heating at a mild temperature of 60 °C without additional solvents. Printed objects are also endowed with multi-materials assembly and recycling capabilities, allowing robotic components to be easily reassembled or recycled after failure. Mechanical properties and deformation behaviour of printed composites and lattices can be tuned significantly to suit various practical applications by altering formulation. Lattice structures with three different architectures were printed and tested in compression: honeycomb, re-entrant, and chiral. They can regain their structural integrity and stiffness after damage, which is of great value for robotic applications. This study extends the performance space of composites, providing a pathway to design printable architected materials with simultaneous mechanical robustness/healability, efficient recoverability, and recyclability.
In this work, cellulose fibres extracted from bamboo culms were used to fabricate two types of cellular materials: rigid foams and fibrous networks. A relatively simple and low-technology fabrication method is presented, using natural binders and blowing agents to manufacture rigid foams, and fibrillation by partial hydrolysis in H2SO4 to manufacture fibrous networks. The compressive response is related to the internal microstructure and processing parameters. In the case of fibrous networks, the achievable relative density range is determined by the length of initial fibres and extent of external fibrillation. The compressive properties are dictated both by the density of the network and strength of the fibrous bridges, showing a linear stiffness-density relationship due to the length of fibres, and an inverse relationship at increased external fibrillation. The rigid foams showed an orthotropic internal microstructure but nearly isotropic compressive response, due to the influence of the interpenetrating void structure on the deformation and fracture mechanisms. The results show the potential of bamboo-fibre porous materials as low cost, lightweight structural materials.