The present study focuses on the preparation of activated carbon (AC) from grape leaves as a low cost, non-toxic, efficient and available adsorbent for the removal of methylene blue (MB) from aqueous solution. The experimental design and data modeling have been carried out using response surface methodology (RSM) through DoE software version 8.0.0. The effect of independent variables including initial dye concentration (100–500 mg/L), pH (3–11), contact time (10–90 min) and adsorbent dosage (0.25–12.25 g/L) on dye removal was determined using the response surface methodology (RSM). The results of analysis of variance (ANOVA) displayed high R2 value of 0.91% for dye removal that shows the developed model has acceptable accuracy. The highest removal efficiency of MB (97.4%) was obtained at optimum condition (pH: 11, adsorbent dosage 12.5 g/L, MB concentration 100 mg/L and contact time 90 min). The results indicated that the initial dye concentration and adsorbent dosage play an important role in increasing the adsorbent efficiency for adsorption of MB. The equilibrium data onto the adsorption of MB were measured using Langmuir and Freundlich, isotherm models. The experimental data obtained follow the Langmuir model (R2 = 0.88). In addition, the second-order kinetic model is more consistent with the adsorption data.
The efficiency of activated carbon produced from grape waste as a low-cost, nontoxic, and available adsorbent to remove Reactive Red 2 from aqueous solution has been investigated. The prepared activated carbon has been characterized by FTIR, SEM, and BET. The results of characterization indicate the successful conversion of grape waste into mesoporous AC with desirable surface area consist of different functional groups. The results of statistical modeling displayed high value of 0.97% for dye removal that shows the developed model has acceptable accuracy. The effect of independent variables indicated that the highest adsorption (96.83%) obtained at pH 3, adsorbent dosage of 12.25 g/L, and initial dye concentration of 100 mg/L when the adsorption time was 90 min. The results of isotherms modeling showed that the data fit well with the Langmuir (type II). The kinetic studies using pseudofirst-order and pseudosecond-order models pointed out that the type (I) of pseudosecond-order kinetic model provided the best fit to the adsorption data. Parameters of thermodynamics including Gibbs energy () and were calculated. The values of indicated that the dye adsorption of RR2 is spontaneous. The agricultural wastes due to special points such as low-cost, availability, and high ability to produce an adsorbent with high efficiency to remove dye can be proposed for water and wastewater treatment.
1 October 2019 in Desalination and Water Treatment