Haematococcus pluvialis is a microalgae actively studied for the production of natural astaxanthin, which is a powerful antioxidant for human application. However, it is economically disadvantageous for commercialization owing to the low productivity of astaxanthin. This study reports an effective screening strategy using the negative phototaxis of the H. pluvialis to attain the mutants having high astaxanthin production. A polydimethylsiloxane (PDMS)-based microfluidic device irradiated with a specific light was developed to efficiently figure out the phototactic response of H. pluvialis. The partial photosynthesis deficient (PP) mutant (negative control) showed a 0.78-fold decreased cellular response to blue light compared to the wild type, demonstrating the positive relationship between the photosynthetic efficiency and the phototaxis. Based on this relationship, the Haematococcus mutants showing photosensitivity to blue light were selected from the 10,000 random mutant libraries. The M1 strain attained from the phototaxis-based screening showed 1.17-fold improved growth rate and 1.26-fold increases in astaxanthin production (55.12 ± 4.12 mg g⁻¹) in the 100 L photo-bioreactor compared to the wild type. This study provides an effective selection tool for industrial application of the H. pluvialis with improved astaxanthin productivity.

Expectation for renewable energy is increasing due to environmental pollution such as fossil fuel depletion, CO₂ emission, and harmful gases. Therefore, in this study, extracted sugars of microalgae, which cause algal blooms and crude glycerol, a biodiesel industry byproduct, were used simultaneously to produce 2,3-BDO. The 2,3-BDO production using only extracted algal sugars was about 4.8 g/L at 18 h, and the production of 2,3-BDO using both extracted algal sugar and crude glycerol was about 7 g/L at 18 h. It was confirmed that the main culture with crude glycerol was increased 1.5-fold compared to the case of using only extracted algal sugars. In addition, four components of the main medium (ammonium sulfate, casein hydrolysate, yeast extract, and crude glycerol) were statistically optimized and the concentrations of the medium were 12, 16, 12, and 13 g/L, respectively. In addition, the final 2,3-BDO production was about 11g/L, which 1.6-fold higher than before the optimization process. As a result, it was confirmed that 2,3-BDO production is possible through the simultaneous use of algal sugars and crude glycerol, which can greatly contribute to the development of zero-waste processes.

Food allergy is a chronic disease that is increasing all over the world, and it can even lead to a loss of life. To prevent any incidents resulting from food allergies, most countries keep strengthening their food allergen labeling requirements domestically and internationally, with a constant monitoring system against undeclared allergens and recall of offending products. In order to avoid economic losses to industry and damages to international relations from undeclared allergens, it is necessary to confirm each country’s regulatory policy on food allergen labeling prior to exportation. Another required action is to try for a reduction of the cross-contamination risk of the allergens during manufacturing and storage, which should be verified by using an accurate and reliable analysis of food allergens. This paper is intended to provide an introduction to the regulation of food allergen labeling by country, allergen management methods to avoid cross-contamination, and allergen detection methods using ELISA, PCR, and LC/MS. Changes of allergenicity during thermal or nonthermal processing also will be investigated in our review. This review will be helpful for the food industry to better understand patients suffering from food allergies and to manage food allergens in food manufacturing.