This paper presents a theory to utilise the longitudinal vibration in bogies as a dynamic vibration absorber (DVA) to reduce the vertical bending vibration of railway vehicle carbodies in a simple and easy way. This study focuses upon the interaction between carbody vertical bending and bogie longitudinal motion, and the condition for tuning the natural frequency of the bogie motion to the target carbody vibration is derived theoretically using a very simple formula. Numerical and experimental studies are then outlined to validate the theory and formula, and the DVA effects are observed from both of them. The effectiveness of the method is also confirmed from a running test with a Shinkansen train on a commercial line.
An analytical method to investigate the three-dimensional (3D) flexural vibration of railway vehicle car bodies is presented in this article. In the method, a car body is modeled as a box-type structure consisting of plates and beams. The condition to connect components is satisfied by introducing artificial springs at their joints. The detailed analytical procedure is described. Some numerical calculations are carried out employing a commuter vehicle, which has a stainless steel car body, as an example. The numerical results are compared with the measured data to evaluate the validity of the model. Although the target vehicle has complicated mode shapes, it is shown that the analytical model can express such 3D vibration mode shapes successfully. It is also demonstrated that a good agreement is observed between the calculation results by the above method and the measured data for both stationary excitation and running test.
Reducing railway vehicles’ three-dimensional (3D) elastic vibration is needed to improve passenger comfort. This paper presents a 3D analytical model and parameter determination method for the elastic vibration of a carbody. The carbody is modelled as a simple box-type structure consisting of an anisotropic 3D elastic body treated as a continuous system. This model can express complicated 3D elastic vibration (such as lateral–vertical coupled vibration) with fewer degrees of freedom and at a lower computational cost than the detailed finite element model. A model parameter determination method using particle swarm optimisation was also proposed. Application to a Shinkansen-type test vehicle showed good agreement between measured and calculated results with a maximum natural frequency differences of the targeted six elastic vibration modes within 0.86%, indicating the effectiveness of the proposed model and parameter determination method.