A new design of a two-stage cycloidal speed reducer is presented in this paper. A traditional two-stage cycloidal speed reducer is obtained by the simple combination of single-stage cycloidal speed reducers. A single-stage reducer engages two identical cycloid discs in order to balance dynamical loads and to obtain uniform load distribution. Consequently, the traditional two-stage reducer has four cycloid discs, in total. The newly designed two-stage cycloidal speed reducer, presented in this paper, has one cycloid disc for each stage, that is, two cycloid discs in total, which means that it is rather compact. Due to its specific concept, this reducer is characterized by good load distribution and dynamic balance, and this is described in the paper. Stress state analysis of cycloidal speed reducer elements was also realized, using the finite elements method (FEM), for the most critical cases of conjugate gear action (one, two, or three pairs of teeth in contact). The results showed that cycloid discs are rather uniformly loaded, justifying the design solution presented here. Experimental analysis of the stress state for cycloid discs was realized, using the strain gauges method. It is easy to conclude, based on the obtained results, that even for the most critical case (one pair of teeth in contact) stresses on cycloid discs are in the allowed limits, thus providing normal functioning of the reducer for its anticipated lifetime.
Traditional cycloidal speed reducers (with two cycloid discs per one stage, mutually turned by an angle of 180°) are well known for their remarkable dynamic stability. This paper analyses dynamic behaviour of a two-stage cycloidal speed...
In order to reduce the greenhouse effect caused by CO2 emissions, a lot of car manufacturers are developing battery electric vehicles (BEVs). Almost all of these vehicles have a traditional powertrain layout with the drive unit located in the car body. However, in recent years, a new technology called in-wheel motors has appeared. It significantly improves handling and manoeuvrability of vehicles but it also presents a challenge for both researchers and manufacturers. Since the motors are fitted into a limited space, they must provide high torque and high efficiency. When a reducer is used, the amount of torque needed is decreased several times, hence the overall dimensions of the motor are reduced. This paper studies a number of issues such as the basic concepts of the in-wheel hub drive systems, traction balance, preliminary gear ratio and possible design solutions for reducers used in in-wheel hub drive units. Characteristics of single-stage planetary and cycloidal reducers are analysed in detail. The results show that planetary reducers have an advantage if a lower gear ratio is needed.