Gear trains applied to automotive transmissions and combustion engines are potential excitation sources of undesired whine noise. Consequently, the prediction of gear whine issues in an early stage of the product development process is strongly requested. Beside the actual excitation mechanism which is closely related to the gear's transmission error, the vibratory behavior (e.g. resonances) of other affected components like shafts, bearings and housing plays an important role in terms of structure borne noise transfer. The paper deals with gear contact models of different degree of detail, which are embedded in a multi-body dynamics (MBD) environment. Since gear meshing frequency and their harmonics may easily reach up to 5 kHz or even 10 kHz, applied gear contact models must be highly efficient with respect to calculation performance. Otherwise, major requirements of the development process in terms of process time can not be satisfied as is the case with FEA-based contact models. Models are developed for spur and helical gears, containing contact point search and force calculation. Tooth deformations are covered as well as friction forces. Resolution of contact is preliminary based on the ideal tooth geometry, deviations from the ideal geometry caused by shape modifications and manufacturing tolerances are considered in a subsequent step. In order to cover edge loading effects the approach reflects gear misalignment, too. A comparison to experimental data for a two gear stage test-rig is performed across the engine speed range. It turned out that the knowledge of the detailed flank geometry is the major prerequisite for a reliable prediction of gear whine excitation and transmission error.
16 September 2022 in The International Journal of Advanced Manufacturing Technology
Undesired vibration is a common issue when dealing with manufacturing machines, especially when dealing with thin structures. To decrease the external disturbance sensitivity of such systems, represented for example by machine tool quill, the auxiliary cable structure is attached to the system. The auxiliary cable structure increases system damping and decreases undesired structure vibrations by the passive or active way, depending on the deployment and purpose. In this article, cables are attached to the end-effector to suppress undesired vibrations and related experimental stand is prepared. Experimental stand parameters are identified using least square method. The control strategy using pole placement is presented and its suitability is verified using external disturbance force. The frequency analysis shows the promising behaviour of controlled cable structure attached to the original system as well as the experimental results.
This paper deals with controlling the swing-up motion of the double pendulum on a cart using a novel control. The system control is based on finding a feasible trajectory connecting the equilibrium positions from which the eigenfrequencies of the system are determined. Then the system is controlled during the motion between the equilibrium positions by the special harmonic excitation at the system resonances. Around the two equilibrium positions, the trajectory is stabilized by the nonlinear quadratic regulator NQR (also known as SDRE – the State Dependent Riccati Equation). These together form the control between the equilibrium positions demonstrated on the double pendulum on a cart.