Photovoltaic (PV) panels convert a certain amount of incident solar radiation into electricity, while the rest is converted to heat, leading to a temperature rise in the PV. This elevated temperature deteriorates the power output and induces structural degradation, resulting in reduced PV lifespan. One potential solution entails PV thermal management employing active and passive means. The traditional passive means are found to be largely ineffective, while active means are considered to be energy intensive. A passive thermal management system using phase change materials (PCMs) can effectively limit PV temperature rises. The PCM-based approach however is cost inefficient unless the stored thermal energy is recovered effectively. The current article investigates a way to utilize the thermal energy stored in the PCM behind the PV for domestic water heating applications. The system is evaluated in the winter conditions of UAE to deliver heat during water heating demand periods. The proposed system achieved a ~1.3% increase in PV electrical conversion efficiency, along with the recovery of ~41% of the thermal energy compared to the incident solar radiation.

In the current study, a phase change material (PCM) contained in an insulated concrete block is tested in extremely hot weather in the United Arab Emirates (UAE) to evaluate its cooling performance. An insulated chamber is constructed behind the block containing PCM to mimic a scaled down indoor space. The effect of placement of the PCM layer on heat gain indoors is studied at two locations: adjacent to the outer as well as the inner concrete layer. The inclusion of PCM reduced heat gain through concrete blocks compared to blocks without PCM, yielding a drop in cooling load indoors. The placement of PCM and insulation layers adjacent to indoors exhibited better cooling performance compared to that adjacent to the outdoors. In the best case, a temperature drop of 8.5% and a time lag of 2.6 h are achieved in peak indoor temperature, rendering a reduction of 44% in the heat gain. In the tested hot climate, the higher ambient temperature and the lower wind speed hampered heat dissipation and PCM re-solidification by natural ventilation. The findings recommend employing a mechanical ventilation in hot climates to enhance regeneration of the PCM to solid state for its optimal performance.

A concentrated photovoltaic system is evaluated as a thermal energy source employing phase change material to meet the domestic water heating demand. A paraffin wax-based phase change material is selected with a 58 °C melting point to store enough thermal energy to match the hot water demand in the buildings. The energy performance of the concentrated photovoltaics containing phase change materials is compared to that of the reference to determine the increased energy outputs due to the heat removal by the material. The concentrated photovoltaics-phase change material achieved 30% higher energy output compared to the reference concentrated photovoltaic, thus providing a strong justification for the improved thermal management design. An enthalpy-based thermal model is developed to compare the experimental results with model predictions, confirming a reasonable agreement between the results. The model is used determine the optimum melting point and container size for different phase change materials under different radiation concentrations for the hot climate of the United Arab Emirates.