Novel rutile TiO2 films with primary microspheres and secondary nanospheres have been deposited on glass substrates via a hydrothermal process by using titanium(IV) butoxide in the presence of toluene and HCl at 160 °C and time period varying from 4 to 8 h. The TiO2 films were characterized using XRD, SEM, FT-Raman, etc. techniques.
Nanocrystalline cadmium sulfoselenide thin films have been synthesized using a self-organized arrested precipitation technique with different deposition times using triethanolamine as a complexing agent. Optical, structural, morphological and photoelectrochemical solar cell properties were investigated as a function of deposition time. A UV-Vis-NIR absorption study suggested a direct allowed transition type and the band gap energy decreased from 2.01 to 1.86 eV with the increase in deposition time. X-ray diffraction studies revealed that the thin films are nanocrystalline by nature with a pure hexagonal crystal structure and a calculated crystallite size of 51–68 nm. Field emission scanning electron microscopy demonstrated that the surface morphology was altered from nanoflakes to assorted nanoflakes–nanospheres and finally to a nanocoral-like morphology. X-ray photoelectron spectroscopy and energy dispersive X-ray spectroscopy showed that the composition of the Cd(SSe) thin films was of good stoichiometry. Electrical conductivity and thermoelectric power measurements confirmed that the deposited films were n-type semiconductors. From J–V measurements, a highest photo-conversion efficiency of 0.57% was achieved. The significant boost in the PEC performance might be due to the improved crystallinity along with lower values of the grain boundary resistance, dislocation density and the microstrain of the Cd(SSe) thin films.
Nanostructured bismuth selenide (Bi2Se3) thin films have been deposited by chemical bath deposition method at room temperature using three different chelating agents, trisodium citrate, triethanolamine and ethylenedimminetetraacetic acid. The structural, morphological, optical and photoelectrochemical properties of Bi2Se3 thin films have been investigated as a function of different chelating agents. X-Ray diffraction studies revealed that the films were nanocrystalline in nature with a rhombohedral crystal structure. Trisodium citrate chelate resulted in Bi2Se3 thin films with poor crystallinity; further improvement in the crystallinity of the films was observed with triethanolamine and ethylenedimminetetraacetic acid chelates. From scanning electron microscopy, a uniform sphere-like morphology having an average sphere diameter of 90 nm was observed with trisodium citrate chelate. In the case of triethanolamine, a fibrous morphology with an average fiber thickness of 60 nm was observed, whereas for ethylenedimminetetraacetic acid chelate, a vertically arrayed petal-like morphology having petal thickness of 50–70 nm was observed. The UV-Vis absorption studies revealed that the band gap energy of the Bi2Se3 thin films with trisodium citrate, triethanolamine and ethylenedimminetetraacetic acid chelates was 1.55, 1.48 and 1.40 eV, respectively. The maximum short circuit current densities (Jsc) of 0.158, 0.214 and 0.284 mA cm−2 and the corresponding open circuit voltages (Voc) of 196, 206 and 217 mV were obtained with trisodium citrate, triethanolamine and ethylenedimminetetraacetic acid chelates, respectively. The Bi2Se3 thin films deposited using triethanolamine and ethylenedimminetetraacetic acid chelates show better photoelectrochemical performance as compared with trisodium citrate chelate.
23 July 2010 in Journal of Sol-Gel Science and Technology