As a dominant water carrier, hydrous silicate minerals and rocks are widespread throughout the representative regions of the mid-lower crust, upper mantle, and subduction zone of the deep Earth interior. Owing to the high sensitivity of electrical conductivity on the variation of water content, high-pressure laboratory-based electrical characterizations for hydrous silicate minerals and rocks have been paid more attention to by many researchers. With the improvement and development of experimental technique and measurement method for electrical conductivity, there are many related results to be reported on the electrical conductivity of hydrous silicate minerals and rocks at high-temperature and high-pressure conditions in the last several years. In this review paper, we concentrated on some recently reported electrical conductivity results for four typical hydrous silicate minerals (e.g., hydrous Ti-bearing olivine, epidote, amphibole, and kaolinite) investigated by the multi-anvil press and diamond anvil cell under conditions of high temperatures and pressures. Particularly, four potential influence factors including titanium-bearing content, dehydration effect, oxidation−dehydrogenation effect, and structural phase transition on the high-pressure electrical conductivity of these hydrous silicate minerals are deeply explored. Finally, some comprehensive remarks on the possible future research aspects are discussed in detail.

Electrical conductivities of the dry hot-pressed sintering gabbro with various mineralogical proportions (Cpx_XPl_100−X, X = 0, 10, 20, 30, 40, 50, 60, 70, 80, 90 and 100 vol% (the signals of Cpx and Pl denote clinopyroxene and plagioclase, respectively) were measured in the YJ-3000t multi-anvil pressure and Solartron-1260 impedance spectroscopy analyzer at temperatures of 773–1073 K and pressures of 1.0–3.0 GPa. At the given pressure conditions, the electrical conductivity and temperature conformed to an Arrhenius relation. For the fixed mineralogical composition of Cpx₅₀Pl₅₀, the electrical conductivities of the samples significantly increased with the rise of temperature, but slightly decreased with increasing pressure. Furthermore, the activation energy and activation volume were determined as 1.06 ± 0.12 eV and 6.00 ± 2.00 cm³/mole, respectively. As for the various mineralogical compositions of dry gabbro, the electrical conductivities of the samples increased with the rise of volume percentage of clinopyroxene (Cpx) at 1.0 GPa. It is proposed that the main conduction mechanism is the small polaron, owing to the positive relation between the electrical conductivity and the iron content in samples. On the basis of these obtained conductivity results, laboratory-based electrical conductivity–depth profiles for the hot-pressed sintering gabbro with various mineralogical proportions and temperature gradients were successfully established. In conclusion, although the present acquired electrical conductivity results on the dry hot-pressed sintering gabbro with various mineralogical proportions cannot explain the high conductivity anomaly in the oceanic crust and West African craton, it can provide one reasonable constraint on the mineralogical composition in these representative gabbro-rich regions.

In this work, a series of electrical conductivities of pyrite-bearing dacite were measured under 10⁻¹–10⁶ Hz, 573–973 K, 1.0–3.0 GPa, and different pyrite contents ranging from 0 vol.% to 20 vol.%) using a Solartron–1260 A impedance analyzer. For the dacite sample with 5 vol.% pyrite, the electrical conductivity of the dacite increased with temperature but slightly decreased when the pressure was increased from 1.0 GPa to 3.0 GPa. In the temperature range of 573–973 K, the bulk electrical conductivity of the pyrite-bearing dacite gradually increased with increasing pyrite percentage from 0 vol.% to 20 vol.% at 1.0 GPa. Thus, a positive correlation between the electrical conductivity of the sample and the pyrite content was typically observed. In light of the significant enhancement in the electrical conductivity of the interconnected pyrite in the dacite, the value of the percolation threshold was determined as 7 vol.%. Furthermore, the dominant conduction mechanism of the small polaron for pyrite-bearing dacite was proposed from our obtained results on the chemical compositions and activation enthalpies under high-temperature and high-pressure conditions. A comprehensive consideration of our constructed electrical conductivity–depth profile based on the electrical conductivity of the pyrite-bearing dacite, can provide a good constraint on the volume of pyrite in dacite for high-conductivity Duobaoshan island arc. In conclusion, the presence of pyrite in dacite can provide a reasonable explanation for the high-conductivity anomaly observed in the region of Duobaoshan island arc.