The relative sliding between tooth surfaces is the main cause of tooth wear and power loss, which directly affects the transmission efficiency and durability of gear. The aim of this paper is to provide a method to design such spur gear with low sliding ratio (LSR). Based on kinematics, differential geometry and contact path, the general mathematical models of the generating rack, the pinion and the mating gear tooth profiles are established in turn. Then, according to the relationship between the contact path and sliding ratio, a contact path described by a cubic function is proposed to construct a spur gear drive with low sliding ratio. In order to ensure the continuity of action and non-interference, solid models of the mated gear pair are established, and the motion simulation is carried out by an example. Moreover, the effects of the contact path function coefficients on sliding ratio, tooth shape, and contact ratio are analyzed. Meshing efficiency and tooth wear of LSR gear drive are evaluated by comparing with those of the involute gear drive. The results show that, this LSR spur gear drive has higher transmission efficiency and better anti-wear performance.

The relative sliding at the meshing point directly affects the contact and lubrication characteristics of the gear pair and is an important factor of gear wear and power loss. In this study, for investigation of a new type of low sliding ratio (LSR) gear pair whose tooth profile is constructed by a cubic function, a three-dimensional (3D) mixed elastohydrodynamic lubrication (EHL) line contact model was established with consideration of the effect of tooth profile geometry, transient motion characteristics, load distribution, and machining roughness. The distribution of the center film thickness of the LSR gear along the meshing line was predicted through an example the result of which was compared with a typical line contact EHL formula to verify the model. In addition, the difference was investigated in film thickness distribution of friction coefficient and temperature rise between LSR spur gears and involute spur gears. Hence, the effect of 3D rough tooth surface on the contact lubrication characteristics of LSR gears was discussed. The results demonstrated that the minimum center film thickness of the LSR gear appeared at the alternating point of the concave and convex tooth surfaces. At the same time, compared with the involute gear, the LSR gear significantly increased the film thickness at the start and ending points of the meshing and reduced the friction coefficient and the flash temperature rise.

A design method of low sliding ratio face gear drive is presented. The rack and gear meshing pair with a low sliding ratio is obtained by constructing the contact path. The face gear is then formed by this gear, and its tooth width characteristics are analyzed. Combined with the explicit solution of the meshing point of the tooth surface, a method to solve the sliding ratio of the proposed face gear pair is given, and the effects of relevant design parameters on the sliding ratio are analyzed. Moreover, the rationality of the tooth profile design is verified by 3D modeling and motion simulation. The proposed face gear pair has a lower sliding ratio, as well as larger tooth width, than those of traditional face gear drive (the pinion is involute spur gear) with the same basic parameters. The results of this study can provide points of reference for reducing friction and improving the mechanical efficiency of face gear drives.