Sergey Degtyarev

Dr. Sergey Degtyarev

Samara National Research University, Samara, Samarskaya Oblast’, Russia
orcid

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 May 2017 in Journal of Modern Optics
Verified
Journal Article
Closed access
Muhammad Ali ButtMuhammad Ali Butt
Muhammad Ali Butt
SDSergey Degtyarev
Sergey Degtyarev
SKS. N. Khonina
S. N. Khonina
NKN. L. Kazanskiy
N. L. Kazanskiy
Trace gases such as H2O, CO, CO2, NO, N2O, NO2 and CH4 strongly absorb in the mid-IR (>2.5 μm) spectral region due to their fundamental rotational and vibrational transitions. CH4 gas is relatively non-toxic, however, it is extremely explosive when mixed with other chemicals in levels as low as 5% and it can cause death by asphyxiation. In this work, we propose a silicon strip waveguide at 3.39 μm for CH4 gas sensing based on the evanescent field absorption. These waveguides can provide the highest evanescent field ratio (EFR)>55% with adequate dimensions. Moreover, EFR and sensitivity of the sensor are highly dependent on the length of the waveguide up to a certain limit. Therefore, it is always a compromise between the length of the waveguide and EFR in order to obtain greater sensitivity.

11 October 2018 in Physical Review A
Verified
Journal Article
Closed access
PDF file
SKS. N. Khonina
S. N. Khonina
AUA. V. Ustinov
A. V. Ustinov
SDSergey Degtyarev
Sergey Degtyarev
We report the formation of a negative energy flux in the case of tight focusing of an arbitrary-order radially polarized annular beam. We consider not only the longitudinal component of the Poynting vector (energy flux density) and the region of its negative values, but also the local inverse energy flux as an integral characteristic over the region of negative values. Theoretically, the Richards-Wolf formulas in the Debye approximation are used to maximize the negative value of the energy flux density on the optical axis in the focal region for the second-order radial polarization (m=2). In this case, the local inverse energy flux, an integral characteristic in the bulk region of negative values, increases with increasing radial polarization order, i.e., for m>2. Jones matrices are employed to show that the result obtained will be valid for azimuthal polarization, as well as for a circularly polarized vortex beam. The results of numerical simulation are in good agreement with theoretical calculations. In addition, taking into account the approximate nature of the Richards-Wolf formulas, we also additionally model the tight focusing of a circular beam based on the solution of Maxwell's equation using the finite element method. It is shown that the local inverse energy flux in the case of the second-order radial polarization will be 1.5 times less than that in the case of the third-order radial polarization. In turn, the use of the fourth-order radial polarization makes it possible to increase the local inverse energy flux by a factor of 2.

4 February 2016 in Applied Optics
Verified
Journal Article
Closed access
PDF file
SDSergey Degtyarev
Sergey Degtyarev
Alexey PorfirevAlexey Porfirev
Alexey Porfirev
SKSvetlana N. Khonina
Svetlana N. Khonina
We demonstrate the possibility of generating a photonic nanojet with a helix shape (photonic nanohelix) at the diffraction of a Gaussian beam on a binary spiral axicon. We investigate the influence of the illuminating beam parameters on the shape and size of the generated photonic nanohelix by solving the Helmholtz equation using the finite element method. The simulated photonic nanohelix has depth of focus (DOF) of 2.21 μm (3.49λ) and FWHM of 304.5 nm (0.48λ), and the intensity maximum is 11.59 times higher than the incident beam maximum intensity. Using a near-field scanning optical microscope with a metal tip, it has been demonstrated that when we illuminate a binary spiral axicon with NA=0.5 and depth of etching of 500 nm by a linearly polarized plane wave (λ=633 nm), the output beam is in the form of a photonic nanohelix of DOF 2.00±0.25 μm (3.16±0.39λ) with FWHM 339±5 nm (0.54±0.01λ).

28 July 2017 in Optics Express
Verified
Journal Article
Open access
PDF file
SKSvetlana Khonina
Svetlana Khonina
SDSergey Degtyarev
Sergey Degtyarev
Dmitry SavelyevDmitry Savelyev
Dmitry Savelyev
AUAndrey Ustinov
Andrey Ustinov
Diffraction patterns formed by axicons with different tip (vertex) angles are analytically and numerically investigated. Results show that the axicon (or tapered dielectric probe) can form an extended axial light beam, a compact evanescent field, a hollow beam, and a collimated beam, depending on the vertex angle. Two-dimensional and three-dimensional models of a tapered dielectric probe show that, with small changes to the vertex angle, light transmitted by the probe is scattered rather than focused, and vice versa. Angle meanings corresponded to boundary transitions have a quantum character and densify as the angle approaches zero. These features should be taken into consideration when manufacturing microaxicons intended for various applications.

1 June 2021 in Optics Express
Verified
Journal Article
Open access
PDF file
Svetlana N. KhoninaSvetlana N. Khonina
Svetlana N. Khonina
SDSergey Degtyarev
Sergey Degtyarev
AUAndrey V. Ustinov
Andrey V. Ustinov
Alexey PorfirevAlexey Porfirev
Alexey Porfirev
We propose a method for the design of metalenses generating and focusing so-called vector Lissajous beams (VLBs), a generalization of cylindrical vector beams (CVBs) in the form of vector beams whose polarization vector is defined by two orders (p, q). The designed metalenses consist of subwavelength gratings performing the polarization transformation of the incident linearly polarized laser beams and a sublinearly chirped lens term for the realization of the beam focusing. The possibility of using VLBs for the realization of laser beams with a complex Poynting vector is theoretically shown. The certain choice of orders (p, q) of the generated VLBs makes it possible to control the type of various electromagnetic field components as well as the components of the complex Poynting vector. For example, in contrast to VLBs, the classical types of CVBs cannot provide an imaginary part in the longitudinal component of the Poynting vector. Such light fields are promising for exciting non-standard forces acting on the trapped nano- and microparticles.

25 July 2018 in Journal of the Optical Society of America B
Verified
Journal Article
Closed access
PDF file
SDSergey Degtyarev
Sergey Degtyarev
SVSergey G. Volotovsky
Sergey G. Volotovsky
Svetlana N. KhoninaSvetlana N. Khonina
Svetlana N. Khonina
We propose a metalens that forms an abruptly autofocusing cylindrically polarized laser beam. The main principle of the metalens is based on combining two elements: a subwavelength polarization grating and an autofocusing sublinearly chirped lens. The subwavelength polarizing grating is calculated separately. It is shown that the grating can effectively convert a linearly polarized initial beam into a radially polarized beam. It is demonstrated that by combining the polarization converter and focusing phase lens, we both increase polarization conversion efficiency and decrease the number of optical elements in an arrangement. Wave propagation through the metalens is numerically simulated with the finite element method, which is implemented in COMSOL Multiphysics software. Polarization and phase conversion is calculated in the near zone behind the metalens. Further wave propagation and focusing are simulated with Rayleigh–Sommerfeld diffraction integrals. Metalenses for forming both diffraction-free and abruptly autofocusing radially polarized beams are under investigation.