In this paper, a new approach is presented to predict the crack growth path in the rock materials by taking into account the size effect. The proposed approach is an incremental method in which the crack initiation angle for each step is determined from the modified forms of the maximum tangential stress criterion. These modified maximum tangential stress criteria take into account the influence of the higher order terms of the stress series at the crack tip in addition to the singular terms. As an important parameter in the proposed method, the critical distance is also assumed to be size dependent. Finally the incremental method is evaluated by experimental results obtained from Guiting limestone and CJhorveh marble specimens reported in the previous studies. It is shown that the proposed approach can predict the fracture trajectory of cracked specimens with different sizes in good agreement with the experimental results when three terms of Williams series expansion are considered for characterizing the stress field around the crack tip.
1 September 2018 in Journal of the Mechanical Behavior of Biomedical Materials
This work aims to assess both experimentally and analytically the fracture behavior of rock specimens containing sharp V-notches (SV-notches) subjected to mixed mode I/II loading. To this end, firstly, several mixed mode fracture tests were conducted on Brazilian disk specimens weakened by an SV-notch (SVNBD sample), performed in their corresponding center and with various notch opening angles. Secondly, the fracture resistance of the tested samples was predicted using a criterion named MTS-FEM. This approach is based on the maximum tangential stress (MTS) criterion, in which the tangential stress is determined from the finite element method (FEM). Additionally, in the present research, the required critical distance is calculated directly from finite element analyses performed on cracked samples. Comparing the experimental results and the analytical predictions, it is shown that the fracture curves obtained from the MTS-FEM criterion are in agreement with the experimental results. These results are achieved without the need for the calculation of stress series expansion coefficients, as an additional advantage of the proposed approach.