A High Power Impulse Magnetron Sputtering (HiPIMS) method for depositing TiAlN environmental barrier coatings on the surface of Ti-48Al-2Cr-2Nb alloy was developed in view of their exploitation in turbine engines. Three differently engineered TiAlN films were processed and their performance compared. Bare intermetallic alloy coupons and coated specimens were submitted to thermal cycling under oxidizing atmosphere up to 850 °C or 950 °C, at high heating and cooling rates. For this purpose, a burner rig able to simulate the operating conditions of the different stages of turbine engines was used. Microstructures of the samples were compared before and after each test using several techniques (microscopy, XRD, and XPS). Coating-intermetallic substrate adhesion and tribological properties were investigated too. All the TiAlN films provided a remarkable increase in oxidation resistance. Good adhesion properties were observed even after repeated thermal shocks. HiPIMS pretreatments of the substrate surfaces performed before the coating deposition significantly affected the oxidation rate, the oxide layer composition and the coating/substrate adhesion.
The recycling of polypropylene recovered from waste discarded by a composting plant was investigated. The recovery involved a sorting step carried out by means of an optical infrared separator and a subsequent washing treatment. This method of processing allowed us to obtain polypropylene that was only slightly contaminated by other polymeric and inorganic materials. As many tens of tons of polypropylene could be recovered every year in this plant, recycling could be convenient from the economic point of view and beneficial for the protection of the environment. In fact, the landfill of this waste could be reduced in this manner. A possible mechanical recycling route was developed for the recovered plastic. The recycling was carried out by pelletizing the recovered polypropylene, mixing it with a commercial polypropylene feedstock, and manufacturing items by injection molding. In this way, tensile specimens containing different amounts of recycled polypropylene were processed and tested. Their tensile features were compared with those of a commercial polypropylene that was used as a reference. The elastic modulus and tensile strength were slightly worsened when using the recycled plastic, while the strain at failure significantly increased. Nonetheless, the tensile properties of compounds made by mixing recycled and virgin polypropylene were consistent with the characteristics that are expected for polypropylene-based plastics.
This paper deals with the recovery of plastic fractions from waste discarded by an industrial composting plant that processes the organic fraction of municipal solid waste. Polymeric fractions (PE, PP and PET) were sorted from this discarded waste using a NIR separator. The polymeric fractions were then washed to remove residual contaminants and characterized with the aim of assessing their composition. A process of pelletizing and injection molding suitable for producing specimens made of 100% of these recovered materials was set up. The tensile strength and stiffness, as well as the microstructure of the recycled plastics, were investigated. The mechanical features of samples fully made of recycled PE and PP were like those characteristic of virgin polymers. Samples made of PET did not show completely satisfactory properties, as they displayed rather poor elastic modulus and ductility.