The origin of gold and silver deposits in the Southern Kamchatka ore district is considered in terms of a quantitative model of the dynamics of volcanogenic orthomagmatic fluid systems (VOFSs). This model takes into account structural, fluid dynamic, and thermophysical features of phase evolution in hydrothermal fluid systems differing in geometry and structural conditions of the discharge on the surfaces of volcanic edifices. It is shown that VOFSs forming sulfide-rich gold and silver deposits have no stationary impermeable caps in their discharge areas. Rather, for the most part, narrow regions of junction of phase fronts form in their interiors and migrate to the surface of volcanic edifices. Three geothermal system types are predicted by the example of plane and conical fluid conductance zones with a cap horizon: (I) where the shallow decompression boiling zone does not arise at all because of large lateral heat loss, (II) where subsurface decompression boiling zones appear at the beginning of the heat wave formation and then such a zone is practically confined to the cap rocks, and (III) where a quasistationary decompression boiling zone forms after an initial instability period or approach to a thermal equilibrium. Fluctuations or oscillations of decompression boiling zone fronts within a range of depths can exist in type III systems.
In this paper, we discuss the formation conditions of rhyolites and results of their interaction with later portions of basic magmas on the basis of the investigation of melt and fluid inclusions in minerals from a rhyolite xenolith and host neovolcanic basalts of the Cleft segment of the Juan de Fuca Ridge. In terms of bulk chemistry and the compositions of melt inclusions in pyroxene and olivine phenocrysts, the basic rocks of the southern part of this segment are typical MOR basalts. Their olivine, clinopyroxene, and plagioclase crystallized at temperatures of 1160–1280°C and a pressure range between 20 and 100 MPa. The xenolith is a leucocratic rock with negligible amounts of mafic minerals, which clearly distinguishes it from the known occurrences of silicic rocks in the rift valleys of MOR. The rhyolite melt crystallized at temperatures of 900–880°C. The final stages of rhyolite melt crystallization at temperatures of 780–800°C were accompanied by the release of a saline aqueous fluid with high chloride contents. Based on the geochemical characteristics of melt inclusions and melting products, it can be suggested that the magmatic melt was produced by melting of metamorphosed oceanic crust within the Cleft segment under the influence sof saline aqueous fluid trapped in the pores and interstices of the rock. The rock represented by the xenolith is a late differentiation product of such melts. The ultimate products of silicic melt fractionation show high volatile contents: H2O > 3.0 wt %, Cl ∼ 2.0 wt %, and F ∼ 0.1 wt %. The interaction of the xenolith with the host basaltic melt occurred at temperatures equal or slightly higher than those of ferrobasalt melts (1190–1180°C). During ascent the xenolith occurred for a few tens of hours in high-temperature basic magma, and diffusion exchange between the basaltic and silicic melts was very minor.
A quantitative analysis of sublimation of intensely fractured rocks in the mantle wedge was performed using a model of planar fracture channel. The use of dimensionless variables allowed us to...
The experimental results presented below shine a light upon the physics of phase transition processes during melting, intensive evaporation, and subsequent explosive destruction of stony meteorites...
The problem of heat–mass transfer in the permeable areas above the asthenosphere zones was numerically studied based on an examination of the inclusion content in the minerals (olivine and clinopyroxenes) of igneous and metamorphic rocks of the lithospheric mantle and the Earth’s crust; evaluations of thermodynamic conditions of the inclusion formation; and experimental modeling of the influence of hot reduced gases on rocks in the mantle beneath the Siberian craton. The flow of fluids of a certain composition from the upper-mantle magma chambers leads to the formation of zonal metasomatic columns in the ultrabasic mantle lithosphere in the permeable zones of deep faults (starting from the lithosphere base at 6–7 GPa). When petrogenic components enter from the magma pocket, depleted ultrabasic lithospheric mantle rocks change to substrates, which can be considered as the deep counterparts of crustal rodingites. Other fluid compositions result in strong calcination and pronounced salinization of the metasomatized substrates or an increase in the garnet content of the primary ultrabasic matrix. A region of alkaline rocks forms above these areas, which changes to pyroxenes, amphiboles, and biotites. The heat–mass transfer modeling for the two-velocity hydrodynamic model shows that gas–fluid and melt percolation lead to an increase in the thermal front velocity under convective heating and a pressure drop in flow. It is also shown that grospidites are considered to be eclogites, are found in the permeable zones of the lithospheric mantle columns serving as conduits for the melt/fluids and represent the products of the carbonated metasomatic columns. The carbonization caused by proto-kimberlite melts may essentially decrease the diamond grade of kimberlites due to carbon oxidation.
—For a multirate approximation, we have determined the dynamics of rock heating by a magmatic-fluid flow in a flat permeable zone cutting the cratonic lithosphere of the Siberian Platform from a magma chamber at a depth of 50 km to the Earth’s surface. This dynamics is compared with the dynamics of infiltration metasomatism in a three-layer lithosphere section: (1) harzburgitic mantle (depth 50–40 km), (2) crystalline basement (39–7 km), whose composition was simulated by the section of rocks hosting the skarn deposits of the Aldan Shield, and (3) platform cover (6–0 km), with its simplified rock compositions specified on the basis of the rock compositions in the southern and northern parts of the trap area of the Siberian Platform. Numerical modeling of the metasomatic transformation of rocks was performed in a multireservoir flow reactor, using the Selektor software. The initial composition of fluids in a magmatic source varied from highly reduced (water–methane) to ordinary (water–acid) (lg pO2 from –13.0 to –12.0). The obtained balances of the interacting phases show no significant change in the mass of aluminosilicate rocks in the mantle and Earth’s crust sections and a significant loss of their mass under replacement of carbonate and sulfate deposits.