The good catalytic activity, resistance to iodine corrosion, and stability of carbon materials make them ideally suited for the fabrication of counter electrodes used in dye-sensitized solar cells (DSSCs).
A semiconductor oxide composite consisting of ZnO nanorods (NRs) and ZnO inverse opal (IO) was fabricated and used in the photoanode of quantum dot-sensitized solar cells (QDSSCs). Using polystyrene spheres 500, 800, 1000, and 1500 nm in diameter as the IO template, ZnO composites and corresponding QDSSCs with ZnO IOs of different pore sizes were fabricated. The oxide composite prepared with ZnO IOs of different pore sizes showed similar micro-morphologies; however, the photovoltaic performance of the QDSSCs based on these composites varied greatly. The QDSSCs based on the ZnO composite achieved high power conversion efficiencies (PCEs) of more than 6%, and the maximum PCE was 7.26% when the ZnO IO pore diameter in the composite was 800 nm. This resulted in very high PCE values for the QDSSCs using CdS/CdSe quantum dot sensitizers. With further interface modifications of NH4F and ZnS, the QDSSC achieved an even higher PCE value of 11.38%. Subsequently, the effects of ZnO IO pore size in the composite on QDSSC performance were investigated.
Owing to their high surface area and porosity, metal-organic frameworks (MOFs) have been gradually employed for a myriad of applications ranging from sensing, pollutant adsorption, and drug delivery to environmental remediation and catalysis. Magnetic nanoparticles-metal-organic frameworks (MMOFs) hybrid materials can facilitate facile removal of MOFs from solutions. In this report, we report the synthesis of Fe3O4@UiO-66 by encapsulation and simulated the drug loading and release by studying the adsorption and release of AO7. Thus, we loaded these MMOFs with AO7 and found that they were able to trigger and control its release by simply applying an external magnetic field. The magnetic field heats the magnets in the MOF, which causes the load to burst from the framework.
A photoelectric conversion efficiency (PCE) of 4.9% was obtained under 100 mW cm −2 illumination by quantum-dot-sensitized solar cells (QDSSCs) using a CdS/Mn : CdSe sensitizer. CdS quantum dots (QDs) were deposited on a TiO 2 mesoporous oxide film by successive ionic layer absorption and reaction. Mn 2+ doping into CdSe QDs is an innovative and simple method—chemical bath co-deposition, that is, mixing the Mn ion source with CdSe precursor solution for Mn : CdSe QD deposition. Compared with the CdS/CdSe sensitizer without Mn 2+ incorporation, the PCE was increased from 3.4% to 4.9%. The effects of Mn 2+ doping on the chemical, physical and photovoltaic properties of the QDSSCs were investigated by energy dispersive spectrometry, absorption spectroscopy, photocurrent density–voltage characteristics and electrochemical impedance spectroscopy. Mn-doped CdSe QDs in QDSSCs can obtain superior light absorption, faster electron transport and slower charge recombination than CdSe QDs.