A single frequency ring fiber laser is reported based on a cladding-pumped ytterbium-doped fiber (YDF). A medium concentration polarization maintaining (PM) YDF is utilized in ring cavity as a saturable absorber that acts as an ultranarrow bandwidth filter. Here, by making use of double-clad and PM fibers in the cavity configuration, thermal noises are notably damped and the frequency instability is minimized due to the temperature fluctuation and polarization variation. The laser yields up to 35 mW of a stable single longitudinal mode output at 1079.68 nm, whereas the corresponding linewidth is estimated less than 6 kHz. Subsequently, a fiber amplifier is employed to boost up power to 5.21 W with the slope efficiency of 45.6%. The amplifier steadily operates below the stimulated Brillouin scattering threshold power. The signal-to-noise ratio is measured to be higher than 70 dB, while the laser linewidth remains unchanged. The relative intensity noise of the laser at the relaxation oscillation frequency of 173 kHz is determined to be -115 dB/Hz, which approaches to -134 dB/Hz at frequencies over 500 kHz.
The objective of this work was to investigate the surface wettability alteration of the titanium and 316L grade stainless steel by nanosecond pulsed laser processing method. For this purpose, various processing conditions were studied extensively. Different analyses, including the study of the surface morphology, free energy, oxidation, and roughness changes, were assessed in correlation with wettability. It is shown that laser processing in air up to 1 J/cm2 laser fluences enhances the surface roughness which in turn promotes the hydrophilicity. The shape and distribution of the created surface structures are also effective in this regard. On the other hand, the surface free energy as well as oxygen content also increases significantly on the laser-irradiated surfaces. According to these results, it is more logic to conclude that all of these cooperative chemical and physical changes are involved in increasing the surface wettability and causing it to be more hydrophilic.
14 December 2015 in The European Physical Journal Plus