To study and understand the importance of Internet of Things-driven citizen science (IoT-CS) combined with data satisficing, we set up and undertook a citizen science experiment for air quality (AQ) in four Pakistan cities using twenty-one volunteers. We used quantitative methods to analyse the AQ data. Three research questions (RQ) were posed as follows: Which factors affect CS IoT-CS AQ data quality (RQ1)? How can we make science more inclusive by dealing with the lack of scientists, training and high-quality equipment (RQ2)? Can a lack of calibrated data readings be overcome to yield otherwise useful results for IoT-CS AQ data analysis (RQ3)? To address RQ1, an analysis of related work revealed that multiple causal factors exist. Good practice guidelines were adopted to promote higher data quality in CS studies. Additionally, we also proposed a classification of CS instruments to help better understand the data quality challenges. To answer RQ2, user engagement workshops were undertaken as an effective method to make CS more inclusive and also to train users to operate IoT-CS AQ devices more understandably. To address RQ3, it was proposed that a more feasible objective is that citizens leverage data satisficing such that AQ measurements can detect relevant local variations. Additionally, we proposed several recommendations. Our top recommendations are that: a deep (citizen) science approach should be fostered to support a more inclusive, knowledgeable application of science en masse for the greater good; It may not be useful or feasible to cross-check measurements from cheaper versus more expensive calibrated instrument sensors in situ. Hence, data satisficing may be more feasible; additional cross-checks that go beyond checking if co-located low-cost and calibrated AQ measurements correlate under equivalent conditions should be leveraged.

For this article, a low-cost, compact, and flexible inkjet-printed electromagnetic sensor was investigated for its chemical and biomedical applications. The investigated sensor design was used to estimate variations in the concentration of chemicals (ethanol and methanol) and biochemicals (hydrocortisone—a chemical derivative of cortisol, a biomarker of stress and cardiovascular effects). The proposed design’s sensitivity was further improved by carefully choosing the frequency range (0.5–4 GHz), so that the analyzed samples showed approximately linear variations in their dielectric properties. The dielectric properties were measured using a vector network analyzer (VNA) and an Agilent 85070E Dielectric Probe Kit. The sensor design had a resonant frequency at 2.2 GHz when investigated without samples, and a consistent shift in resonant frequency was observed, with variation in the concentrations of the investigated chemicals. The sensitivity of the designed sensor is decent and is comparable to its non-flexible counterparts. Furthermore, the simulation and measured results were in agreement and were comparable to similar investigated sensor prototypes based on non-flexible Rogers substrates (Rogers RO4003C) and Rogers Droid/RT 5880), demonstrating true potential for chemical, biomedical applications, and healthcare.