Two-dimensional (2D) semi-conductive transition metal dichalcogenides (TMDCs) have shown advantages for logic application. Complementary metal-oxide-semiconductor (CMOS) inverter is an important component in integrated circuits in view of low power consumption. So far, the performance of the reported TMDCs-based CMOS inverters is not satisfactory. Besides, most of the inverters were made of mechanically exfoliated materials, which hinders their reproducible production and large-scale integration in practical application. In this study, we demonstrate a practical approach to fabricate CMOS inverter arrays using large-area p-MoTe2 and n-MoS2, which are grown via chemical vapor deposition method. The current characteristics of the channel materials are balanced by atomic layer depositing Al2O3. Complete logic swing and clear dynamic switching behavior are observed in the inverters. Especially, ultra-low power consumption of ∼0.37 nW is achieved. Our work paves the way for the application of 2D TMDCs materials in large-scale low-power-consumption logic circuits.
Two-dimensional (2D) materials, such as graphene and transition metal dichalcogenides (TMDCs), are highly appealing in the fields of electronics, optoelectronics, energy, etc. Graphene, with high conductivity and high carrier mobility, is an excellent candidate for transparent electrodes. TMDCs have remarkably strong light absorption in the range of visible to infrared wavelength. High-performance photodetectors are expected to achieve through the combination of graphene and TMDCs. Nowadays, near-infrared (NIR) photodetectors play significant roles in many areas. MoTe2 with bandgap energy of about 1.0 eV in its bulk form is a promising material for cost-saving NIR photodetectors. Thus far, only a few of the reported studies on NIR photodetectors built on MoTe2/graphene heterostructures have achieved high responsivity and short response time simultaneously in one device. In this study, we fabricate graphene–MoTe2–graphene vertical van der Waals heterostructure devices through chemical vapor deposition (CVD) growth, wet transfer method, and dry etching technique. Under 1064 nm laser illumination, we acquire responsivity of as high as 635 A/W and a response time of as short as 19 μs from the as-fabricated device. Moreover, we acquire higher responsivity of 1752 A/W and a shorter response time of 16 μs from the Al2O3-encapsulated device. Our research drives the application of 2D materials in the NIR wavelength range.