Bin Cai

Dr. Bin Cai

orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 March 2021 in IEEE Sensors Journal
Verified
Journal Article
Closed access
TCTianhao Cheng
Tianhao Cheng
BWBuhong The Wang
Buhong The Wang
Zhen WangZhen Wang
Zhen Wang
RDRunze Dong
Runze Dong
BCBin Cai
Bin Cai
Conventional transmit subarray partitioning schemes of phased-MIMO radar will cause several problems, the reduction of array aperture, the increase of feeding network complexity and optimization algorithms time cost. Focus on the problems above, this paper proposes a deep learning-based interleaved sparse transmit subarray partitioning method. Firstly, the training data is generated by phased-MIMO array manifold matrix. Secondly, a dimensionality reduction method for radar data is introduced to reduce the dimensionality of the sample data while minimizing information loss. Then, a lightweight convolutional neural network is constructed for training and the optimal array structures is selected by classification. Finally, linear and plane arrays experiment results show that our proposed method can achieve 97.95% classification accuracy, better than other conventional dimensionality reduction methods and neural networks; compared with the traditional SCP partitioning method, our proposed method has similar beampattern sidelobe level and DOA estimation accuracy, but the time cost is greatly reduced.

8 May 2023 in Remote Sensing
Verified
Journal Article
Open access
PDF file
BCBin Cai
Bin Cai
XHxiaolong HAO
xiaolong HAO
LCLi Chen
Li Chen
JLJia Liang
Jia Liang
TCTianhao Cheng
Tianhao Cheng
YLYing Luo
Ying Luo
Through formation flying, the distributed spaceborne SAR(synthetic aperture radar) system can increase the number of spatial degree of freedoms (DOFs) and provide flexible multi-baselines for SAR-GMTI (ground moving target indication), which improves the system performance. This paper proposes an a priori knowledge-based adaptive clutter cancellation and moving target detection technique applied to the distributed spaceborne SAR-GMTI systems. Firstly, the adaptive clutter cancellation technique is exploited to suppress the ground clutter. A priori knowledge, such as road network information, is integrated to the adaptive clutter cancellation processor to reduce any moving target steering vector mismatch. Secondly, adaptive matched filter (AMF) and adaptive beamformer orthogonal rejection test (ABORT) are exploited as adaptive detection techniques for moving target detection. Due to the dense road network, the moving target steering vector estimation may be ambiguous for the different position and orientation of the roads. The multiple hypothesis testing (MHT) technique is proposed to detect the moving targets and resolve the potential ambiguities. A scheme is exploited to detect, classify, and relocate the moving targets. Finally, simulation experiments and performance analysis have demonstrated the effectiveness and robustness of the proposed technique.

2 November 2022
Verified
Conference Paper
Closed access
PDF file
YXYan Xu
Yan Xu
ZFZhenjun Feng
Zhenjun Feng
LLLiang Li
Liang Li
YCYonggang Chang
Yonggang Chang
QBQiang Bai
Qiang Bai
HZHongbo Zhang
Hongbo Zhang
Given the quality problem of a batch of oil and gas long radius elbow found on site, a quality sampling inspection was carried out. The quality was tested by a penetrant test, geometric dimensions measurement, chemical composition analysis, and a hardness test. Metallographic analysis was carried out about the defects found. It can be seen that no obvious abnormality was found in the profile size, remaining wall thickness, chemical composition analysis, and hardness test results of this batch of elbows. There is a longitudinal crack with a length of 10 mm on the outer surface of the pipe end of the DN50 elbow. According to anatomical analysis, this defect is a shallow crack on the outer surface, with a certain angle between the crack and the outer surface of the pipe. The maximum depth in the cross-section is 0.24 mm, and the vertical depth from the outer surface is 0.12 mm. It is speculated that these cracks occurred before solution treatment and are related to the original defects of the parent pipe or mechanical damage during cold work.

1 July 2022 in International Journal of Surgery Science
Verified
Journal Article
Open access
PDF file
WWWenlin Wang
Wenlin Wang
WLWeiguang Long
Weiguang Long
YLYang Liu
Yang Liu
BCBin Cai
Bin Cai
JLJuan Luo
Juan Luo
Thoracic deformity can be roughly divided into two categories, one is depression deformity the other is protrusion deformity. In general, depression deformity is called pectus excavatum. In the era of open surgery, there is no big problem with this nomenclature. However, in the era of minimally invasive surgery, because the general minimally invasive surgery cannot be used to treat some depression deformities, it is necessary to further classify these deformities. After a long time observations, we found that there was a type of deformity with distinct characteristics, which was the transverse groove in the anterior chest wall, and was significantly different from the hollow of the typical pectus excavatum. This deformity cannot be corrected with standard Nuss procedure. In order to better understand and treat this special deformity, we named it groove chest. We also made a special design for its operation, and finally designed an effective surgical method. Our experience shows that the surgery we designed is an effective technique, which also proves the necessity of treating groove chest as an independent deformity.

8 March 2022 in arXiv
Verified
Preprint
Open access
PDF file
TBTi Bai
Ti Bai
MLMu-Han Lin
Mu-Han Lin
XLXiao Liang
Xiao Liang
BWBiling Wang
Biling Wang
MDMichael Dohopolski
Michael Dohopolski
SJSteve Jiang
Steve Jiang
Medical image registration is a fundamental and vital task which will affect the efficacy of many downstream clinical tasks. Deep learning (DL)-based deformable image registration (DIR) methods have been investigated, showing state-of-the-art performance. A test time optimization (TTO) technique was proposed to further improve the DL models' performance. Despite the substantial accuracy improvement with this TTO technique, there still remained some regions that exhibited large registration errors even after many TTO iterations. To mitigate this challenge, we firstly identified the reason why the TTO technique was slow, or even failed, to improve those regions' registration results. We then proposed a two-levels TTO technique, i.e., image-specific optimization (ISO) and region-specific optimization (RSO), where the region can be interactively indicated by the clinician during the registration result reviewing process. For both efficiency and accuracy, we further envisioned a three-step DL-based image registration workflow. Experimental results showed that our proposed method outperformed the conventional method qualitatively and quantitatively.