The use of channel code is mandatory in current digital communication systems. It allows to access the information on the receiver side despite the presence of noise. In this paper, we are interested in the blind identification of the parameters of an error correcting code from a received noisy data stream. Literature provides a large amount of contributions for this problem in the hard-decision case but few in the soft-decision case. It is well known that soft-decision methods allow significant gain in decoding techniques. Thence, we propose an algorithm which is able to identify the length of a code through a classification process from the bits likelihood values. It highlights a difference of behavior between an i.i.d. sequence and an encoded one. This method does not rely on any a priori knowledge about the encoder involved. Indeed, the distribution of $n$-length code words in an $n$-dimensional space depends on the encoder characteristics. Some areas of this $n$-dimensional space are left vacant because of the redundancy added by the encoder. Despite the presence of noise, it is still possible to detect this phenomenon. Furthermore, an adaptation of a collisions method based on the birthday paradox gives us access to an estimation of the code dimension. Finally, we investigate the performance of this estimation methods to show its efficiency.

The paper proposes a joint semi-blind algorithm for simultaneously cancelling the self-interference component and estimating the propagation channel in 5G Quasi-Cyclic Low-Density Parity-Check (QC-LDPC)-encoded short-packet Full-Duplex (FD) transmissions. To avoid the effect of channel estimation processes when using short-packet transmissions, this semi-blind algorithm was developed by taking into account only a small number (four at least) pilot symbols, which was integrated with the intended information sequence and used for the feedback loop of the estimation of the channels. The results showed that this semi-blind algorithm not only achieved nearly optimal performance, but also significantly reduced the processing time and computational complexity. This semi-blind algorithm can also improve the performances of the Mean-Squared Error (MSE) and Bit Error Rate (BER). The results of this study highlight the potential efficiency of this joint semi-blind iterative algorithm for 5G and Beyond and/or practical IoT transmission scenarios.

The paper proposes a joint blind iterative Self-Interference (SI) cancellation, propagation channel estimation and decoding algorithm in Full-Duplex (FD) transmissions via feedback of channel estimates and decoded messages combined with the process of Digital Self-Interference Cancellation (DSIC). Different from the conventional algorithm, the proposed blind algorithm simultaneously estimates the self-interference and propagation channels and decodes messages in each decoding iteration of 5G Quasi-Cyclic Low Density Parity Check (QC-LDPC) codes. The temporary propagation channel estimate and decoded message are fed back to improve the self-interference cancellation and also the channel estimation as well as decoding in the next iteration. The results show that the proposed algorithm outperforms the conventional algorithm, especially at high signal to noise ratio (SNR) and small number of symbols, and requires much less processing time and computational complexity while achieving the convergence performance. The results also show that the proposed algorithm is less sensitive to SI level than the conventional algorithm. The paper further proposes a partial feedback scheme, which only use few feedback symbols for channel estimation, to significantly reduce the processing time and computational complexity while maintaining the performance. These good properties seem quite suitable for a use of this proposed blind iterative algorithm for short-length packet FD transmissions in Internet-of-Things (IoT) applications and green communications.

This paper studies the secrecy coding analysis achieved by the self-jamming technique in the presence of an eavesdropper by considering a short-packet Full-Duplex (FD) transmission developed based on iterative blind or semi-blind channel estimation and advanced decoding algorithms. Indeed, the legitimate receiver and eavesdropper can simultaneously receive the intended signal from the transmitter and broadcast a self-jamming or jamming signal to the others. Unlike other conventional techniques without feedback, the blind or semi-blind algorithm applied at the legitimate receiver can simultaneously estimate, firstly, the Self-Interference (SI) channel to cancel the SI component and, secondly, estimate the propagation channel, then decode the intended messages by using 5G Quasi-Cyclic Low-Density Parity Check (QC-LDPC) codes. Taking into account the passive eavesdropper case, the blind channel estimation with a feedback scheme is applied, where the temporary estimation of the intended channel and the decoded message are fed back to improve both the channel estimation and the decoding processes. Only the blind algorithm needs to be implemented in the case of a passive eavesdropper because it achieves sufficient performances and does not require adding pilot symbols as the semi-blind algorithm. In the case of an active eavesdropper, based on its robustness in the low region of the Signal-to-Noise Ratio (SNR), the semi-blind algorithm is considered by trading four pilot symbols and only requiring the feedback for channel estimation processes in order to overcome the increase in noise in the legitimate receiver. The results show that the blind or semi-blind algorithms outperform the conventional algorithm in terms of Mean Square Error (MSE), Bit Error Rate (BER) and security gap ($S_g$). In addition, it has been shown that the blind or semi-blind algorithms are less sensitive to high SI and self-jamming interference power levels imposed by secured FD transmission than the conventional algorithms without feedback.