Thermo-Electrochemical cells (Thermocells/TECs) transform thermal energy into electricity by means of electrochemical potential disequilibrium between electrodes induced by a temperature gradient (ΔT). Heat conduction across the terminals of the cell is one of the primary reasons for device inefficiency. Herein, we embed Poly(Vinylidene Fluoride) (PVDF) membrane in thermocells to mitigate the heat transfer effects - we refer to these membrane-thermocells as MTECs. At a ΔT of 12 K, an improvement in the open circuit voltage (Voc) of the TEC from 1.3 mV to 2.8 mV is obtained by employment of the membrane. The PVDF membrane is employed at three different locations between the electrodes i.e. x = 2 mm, 5 mm, and 8 mm where ‘x’ defines the distance between the cathode and PVDF membrane. We found that the membrane position at x = 5 mm achieves the closest internal ∆T (i.e. 8.8 K) to the externally applied ΔT of 10 K and corresponding power density is 254 nWcm−2; 78% higher than the conventional TEC. Finally, a thermal resistivity model based on infrared thermography explains mass and heat transfer within the thermocells.
Fiber lasers have long remained relevant for various applications worldwide in many industries. This paper presents a mode-locked ytterbium-doped fiber laser (YDFL) using our home-made topological insulator Bi2Se3 nanosheets (TI Bi2Se3) as the saturable absorber. The fabricated TI Bi2Se3 is transported to the end of the fiber ferrule using an optical deposition process, which is a key ingredient for initiating a pulsed fiber laser. With a pump power of 211.1 mW, the captured repetition rate and pulse width are 8.3 MHz and 6.2 ns, respectively. The length of the setup configuration is approximately 20 m, which corresponds to an output power measurement of 12.4 mW with a calculated pulse energy of 1.5 nJ. There are no significant Kelly sidebands, but the strong stability of the pulsed laser is defined by a high signal-to-noise ratio (SNR) of around 60.35 dB.
1 November 2019 in Energy Conversion and Management