Cutter suction dredgers are important pieces of rock excavation equipment in port and waterway construction. It is valuable but difficult to properly estimate the cutting force on the chisel pick of the cutter suction dredger. In this paper, an analytical model, called the crushed zone expansion induced tensile failure model (CEIT model), is proposed for rock cutting with a chisel pick in order to predict the peak cutting force (Fc) more accurately. First, a review of the existing models for rock cutting with a chisel pick is presented. Next, based on the tensile breakage theory, cavity expansion theory and some hypotheses, the mathematical formula of the CEIT model is obtained. Different from that in the previous models, the effect of the rock on both sides of the chisel pick on Fc, defined as the sidewall effect is considered in the CEIT model. Then, the predicted Fc by the CEIT model is compared with the predicted Fc by existing theoretical models and experimental results to check the validity of the CEIT model. The results show that the CEIT model can well capture the relationships of Fc to the cutting parameters, including cutting width, cutting depth, and rake angle, and can predict the experimental results much better than the existing models. Finally, the sidewall effect and its influence factors according to the CEIT model are discussed.
The bonded-particle model (BPM) is a very efficient numerical method in dealing with initiation and propagation of cracks in rocks and can model the fracture processes and most of macro parameters of rocks well. However, typical discrete element method (DEM) underestimates the ratio of the uniaxial compressive strength to the tensile strength (UCS/TS). In this paper, a new DEM method with a nonlinear elastic tensile model embedded in BPM is proposed, which is named as nonlinear elastic tensile bonded particle model (NET-BPM). The relationships between micro parameters in NET-BPM and macro parameters of specimens are investigated by simulating uniaxial compression tests and direct tension tests. The results show that both the shape coefficient of the nonlinear elastic model and the bond width coefficient are important in predicting the value of UCS/TS, whose value ranging from 5 to 45 was obtained in our simulations. It is shown that the NET-BPM model is able to reproduce the nonlinear behavior of hard rocks such as Lac du Bonnet (LDB) granite and the quartzite under tension and the ratio of compressive Young’s modulus to tensile Young’s modulus higher than 1.0. Furthermore, the stress-strain curves in the simulations of LDB granite and the quartzite with NET-BPM model are in good agreement with the experimental results. NET-BPM is proved to be a very suitable method for modelling the deformation and fracture of rock-like materials.
The open-frame structure of work-class ROVs results in significant model uncertainties, and its motion is strongly disturbed by the umbilical cable. To address these problems, this article developed a nonlinear disturbance observer-based super-twisting double-loop sliding-mode control (NDO-STDSMC) method to achieve trajectory tracking control of work-class ROVs with system uncertainties and external disturbances. First, a new outer-loop controller with a novel reaching law is designed to increase the convergence rate compared with the existing double-loop sliding-mode control (DSMC). Second, an inner-loop controller that combines the advantages of the super-twisting sliding-mode scheme is proposed to guarantee the tracking error converges to zero in finite time. Then, a nonlinear disturbance observer is designed to estimate and compensate for the system uncertainties and external disturbances. The stability of the overall control system is proven by the Lyapunov approach. Finally, comprehensive simulation studies on trajectory tracking control of work-class ROVs are provided to demonstrate the efficiency of the proposed NDO-STDSMC method and its superiority over existing DSMC and STDSMC methods.
23 September 2016 in International Journal for Numerical Methods in Engineering