The purpose of this work was to optimise printable polycaprolactone (PCL)/β-tricalcium phosphate (β-TCP) biomaterials with high percentages of β-TCP endowed with balanced mechanical characteristics to resemble human cancellous bone, presumably improving osteogenesis. PCL/β-TCP scaffolds were obtained from customised filaments for fused deposition modelling (FDM) 3D printing with increasing amounts of β-TCP. Samples mechanical features, surface topography and wettability were evaluated as well as cytocompatibility assays, cell adhesion and differentiation. The parameters of the newly fabricated materila were optimal for PCL/β-TCP scaffold fabrication. Composite surfaces showed higher hydrophilicity compared with the controls, and their surface roughness sharply was higher, possibly due to the presence of β-TCP. The Young's modulus of the composites was significantly higher than that of pristine PCL, indicating that the intrinsic strength of β-TCP is beneficial for enhancing the elastic modulus of the composite biomaterials. All novel composite biomaterials supported greater cellular growth and stronger osteoblastic differentiation compared with the PCL control. This project highlights the possibility to fabricat, through an FDM solvent-free approach, PCL/β-TCP scaffolds of up to 70 % concentrations of β-TCP. overcoming the current lmit of 60 % stated in the literature. The combination of 3D printing and customised biomaterials allowed production of highly personalised scaffolds with optimal mechanical and biological features resembling the natural structure and the composition of bone. This underlines the promise of such structures for innovative approaches for bone and periodontal regeneration.
Background: New technologies can facilitate the transition from pre-clinical to clinical settings. We investigate students’ satisfaction with a novel learning method adopted in access cavity exercises. Methods: Students performed their access cavity on inexpensive, in-house 3D printed teeth. Their performances were evaluated by scanning the prepared teeth with an intraoral scanner and visualized using a mesh processing software. Then, the same software was used to align the tooth prepared by the student and the teacher’s one for self-assessment purposes. Students were asked to answer a questionnaire about their experiences with this new learning method. Results: From the teacher’s perspective, this novel learning approach was easy, straightforward and affordable. Overall, student feedback was positive: 73% found that access cavity assessment by scanning was more useful compared to a visual inspection under magnification and 57% reported that they had a better understanding of errors and mishaps. On the other hand, students pointed out that the material used to print teeth was too soft. Conclusion: The use of in-house 3D printed teeth in pre-clinical training is a simple way to overcome some of the drawbacks associated with extracted teeth, such as limited availability, variability, cross-infection control, and ethical constraints. The use of intraoral scanners and mesh processing software could improve student self-assessment.
1 September 2024 in Minerva Dental and Oral Science
Article: The top 100 most-cited articles in dentistry by authors with Italian affiliation - Minerva Dental and Oral Science 2024 Jun 06 - Minerva Medica - Journals
An important issue with digital impression techniques is the difficulty in replicating the subgingival zone, particularly when abutments are prepared with a vertical finish line. We propose a novel procedure, the reverse subgingival scan (RSS), to depict the subgingival area via digital impression without a retraction cord or the distortion of the sulcus. The software workflow, beginning with a digital dental impression, was performed using Exocad® (Align Technology) and Meshmixer® (Autodesk). The approach is based on the direct alignment of the surface of abutments, which is used as a reference point. The efficacy of the RSS approach was confirmed via fit tests, radiographic control assessments, and evaluations of the rate of tissue compression of the final prosthetic restoration, so long as the provisional had a perfect fit. RSS yields information on the transversal dimension and depth of the gingival sulcus. The procedure depends on the quality and characteristics of the provisional restoration, and is suitable only for cases in which the finish line of the final crown is at the same level or more coronal than that of the provisional.