The air separation system is an important part of aircraft fuel inerting system, which is responsible for the important task of supplying nitrogen-enriched air to the aircraft fuel tank. The flow characteristic of air separation device is the key problem of its design. In this paper, based on one-dimensional fluid simulation software Flowmaster, we did some research on the simulation model of membrane modules, established the simulation model of air separation system, obtained the simulation results of the flow characteristics and analyzed the results in detail. The results showed that under low pressure and flow conditions, compared with the experimental values, the relative error of nitrogen-enriched air and oxygen-enriched air flow rate was about 5%.In the case of high inlet pressure and flow, the pressure loss of the junctions and the long pipeline was larger, and the inlet pressure, outlet pressure and pressure loss of the 12 membrane modules were significantly different. The research work was of reference value for the design optimization of air separation system in aircraft fuel inerting system.

As low-cost, widely distributed and easily accessible renewable clean energy, solar energy has attracted more and more attention. Direct absorption solar collectors can convert solar energy into heat, but their efficiency is closely related to the absorption performance of the working fluid. In order to improve the absorption efficiency of direct absorption solar collectors, an experimental study on the selective absorption of solar energy by hybrid nanofluids was carried out. Five hybrid nanofluids were prepared and characterized, and the energy transfer advantages of hybrid nanofluid over single nanofluid were carefully studied. Experiments have found that the light-to-heat conversion properties of hybrid nanofluids show no obvious advantages or disadvantages compared with single nanofluid, and their performance is closely related to the types of nanoparticles. In addition, the hybrid nanofluid generally has two peaks, exactly the same as the single nanofluid in the mixed component, but the absorption curve is flatter than that of the single nanofluid. Further research of more types of hybrid nanofluids can provide new insights into the use of solar energy.

Solar–thermal conversion and migration characteristics of nanofluids have attracted intensive attention recently. Due to the strong absorption of solar energy, solar collectors with nanofluids have wide applications in many areas including desalination and power generation. Researchers have mainly focused on the macroscopic performance of nanofluids in solar collectors, but the nanoparticles’ migration characteristics with vapor during phase transformation have not been further investigated. Therefore, an experimental investigation on solar–thermal conversion characteristics of nanofluids and migration characteristics with vapor during phase transformation was conducted in this work, in order to verify the enhancement effect of nanoparticles on solar energy absorption and explore the nanoparticles’ migration behavior with vapor. It was found that part of Ag nanoparticles migrate out of the nanofluids with generated vapor by boiling nanofluids, and most of the nanoparticles remained in the nanofluids. In addition, more Ag nanoparticles migrated with vapor with the increased heating power. The concentration of migrated nanofluids was 20.58 ppm with a power of 16.2 W and 31.39 ppm with a power of 20 W. The investigation pointed out the potential danger of nanofluids in the process of utility and provided a reference for the standardized application of nanofluids.