In the present study, a photoelectrochemical process containing seawater as a natural low-cost supporting electrolyte was used to remove ammonium from wastewater in a continuous flow mode. Based on central composite design (CCD), response surface methodology (RSM) was employed to evaluate the performance of the process in ammonia removal. The effect of four main independent parameters, including initial ammonium concentration, hydraulic retention time (HRT), current intensity and initial pH on the removal of ammonia was evaluated by the model. The optimal initial ammonium concentration, HRT, current intensity and initial pH were 917 mg NH 4− N;·L −1, 108 min, 1.8 A and 8.4, respectively. The high coefficients (R2=0.97 and adjusted R2=0.94) obtained by the analysis of variance (ANOVA) demonstrated close correlation between predicted and experimental values. Also, treating the reject water from the sludge dewatering unit as an ammonium-rich wastewater showed the effectiveness of the process for treating real wastewaters (86% ammonium removal). The results revealed that the present process can be an efficient method for ammonium removal from polluted effluents in coastal areas based on the availability of seawater as a cost-efficient supporting electrolyte.
28 January 2014 in Environmental Chemistry Letters
Background: The problems related to conventional Fenton oxidation, including low pH required and production of considerable amounts of sludge have led researchers to investigate chelating agents which might improve the operating range of pH and the use of nano iron particle to reduce the excess sludge. The pyrene removal from contaminated soils by modified Fenton oxidation at neutral pH was defined as the main objective of the current study. Methods: Varying concentrations of H2O2 (0-500 mM) and iron nano oxide (0-60 mM), reaction times of 0.5-24 hours and variety of chelating agents including sodium pyrophosphate, sodium citrate, ethylene diamine tetraacetic, fulvic and humic acid were all investigated at pyrene concentration levels of 100 – 500 mg/kg. Results: By applying the following conditions (H2O2 concentration of 300 mM, iron nano oxide of 30 mM, sodium pyrophosphate as chelating agent, pH 3 and reaction time of 6 hours) the pyrene removal efficiency at an initial concentration of 100 mg/kg was found to be 99%. As a result, the pyrene concentration was reduced from 100 to 93 mg/kg once the above optimum conditions are met. Conclusions: In this research, the modified Fenton oxidation using iron nano oxide at optimum conditions is introduced as an efficient alternative method in lab scale for chemical remediation or pre-treatment of soils contaminated by pyrene at neutral pH.
5 December 2012 in Research on Chemical Intermediates