The availability of fresh water is vital for all human activities and in particular for improving living conditions, health and overall well-being. Pressure on scarce fresh water resources can be reduced by treating and reusing brackish water by advanced membrane treatment technologies. In this study, brackish water originating from effluent discharge of a local coal mine, seawater, groundwater and salt water swimming pool is treated by a laboratory-scale vacuum membrane distillation (VMD) system. VMD is an emerging technology that has the potential to become as important as conventional distillation system and aims to remove particles and dissolved impurities by evaporation and condensation techniques that mimic what occurs in nature. This study validates the mathematical modeling of the transport mechanisms used in the VMD process using data collected for different experimental situations. The response of flux rate to various process operating parameters, including pressure, temperature, flow rate and salinity concentration, is also demonstrated. This thermally driven separation process enables to remove 99.9% of total dissolved solids (TDS) from brackish water. The quality of the permeate water from all four water sources studied is of acceptable standards for potable use; however, it requires mineralization efforts before direct consumption.
1 January 2019 in Desalination and Water Treatment
Membrane distillation (MD) has two major problems: wetting and fouling. MD is rarely employed in wastewater reclamation since the active surfactant in the detergents contained in such water promotes feed water penetration through the membrane. Another difficulty is that the membrane lifetime and the performance of the MD process are both influenced by fouling. The main aim of this paper is to determine the effectiveness of the linear alkylbenzene sulfonate (LAS) concentration in the reduction of contact angle and the prediction of the flux decline with variation of the influent salt concentration. Contact angle was measured for different concentrations of LAS solution as well as different samples of brackish and grey water. The tests were performed with three different types of hydrophobic membranes. A simple empirical model was proposed, and related coefficients were calibrated based on experimental data for contact angles measured for different solutions with the hydrophobic membrane. Flux decline trends during pore wetting was investigated by monitoring the permeate quality through the treatment of synthetic grey water. The effect of membrane fouling during vacuum membrane distillation (VMD) was also studied under different operating conditions. A variety of temperature and pressure combinations as well as several salinity concentrations has been examined. The mathematical based model developed for the permeate flux was used to predict the flux rate of different salinity solutions. It was found that the flux decline could be attributed to the mass transfer resistance of the salt crystals.