Phthalates are synthetic chemicals widely used, mainly as plasticizers, which are ubiquitous and recognized as endocrine-disrupting chemicals. For investigation of phthalate residues leached from PET bottles into drinking water, a simple and sensitive method was developed, validated and applied to a series of real samples. Solid-phase microextraction (SPME) was used in direct immersion mode for concentration of phthalate traces from 10 mL of each water sample. Four commercially available SPME fibers were tested and compared, while six dialkyl phthalates were investigated: dimethyl phthalate (DMP), diethyl phthalate (DEP), diisopropyl phthalate (DiPP), diisobutyl phthalate (DiBP), di-n-butyl phthalate (DnBP) and di-ethylhexyl phthalate (DEHP). The extracted phthalic acid esters were separated and quantified by gas chromatography hyphenated with tandem mass spectrometry (GC-MS/MS) and a detection method based on multiple reaction monitoring (MRM) mode was fully developed, optimized and validated. The fiber which showed the highest ability for extraction of phthalates was DVB/CAR/PDMS which combines a liquid polymeric coating (polydimethyl siloxane and divinylbenzene) with a carboxen porous sorbent layer. The obtained limit of detection was in the range between 0.3 and 2.6 ng mL^-1. Thus, this fiber was used for extraction of phthalates from twelve commercial PET bottled water samples. All investigated water brands showed the presence of two to six phthalates at concentrations between 6.3 and 112.2 ng mL^-1. The highest level was observed for DnBP, followed by DEHP, DiBP, DMP, DEP and DiPP.

The chemical industry explosion in the 20th century has led to increased environmental pollution, affecting fauna, flora, and waterways. These substances alter water’s taste, color, and smell, making it unfit for consumption or toxic. Agricultural water networks face threats from pollution before and after treatment. Some chemical contaminants, like pesticides, are embedded in natural biogeochemical cycles. In this study, we developed a simple and low-cost procedure for the fabrication of needles coated with polydimethylsiloxane (PDMS) as an efficient sorbent for the microextraction of organic pollutant traces from water. The prepared needles were used as an alternative for commercial solid-phase micro-extraction (SPME) devices in analytical chemistry. The PDMS polymeric phase was characterized by Fourier-transform infrared spectroscopy (FT-IR), thermogravimetry (TGA), and scanning electron microscopy (SEM). The PDMS-coated needles were used for extraction of thirteen pesticides by direct-immersion solid-phase microextraction (DI-SPME) from contaminated waters, followed by determination with gas chromatography-mass spectrometry (GC-MS). The developed analytical method showed limits of detection (LODs) between 0.3 and 2.5 ng mL⁻¹ and RSDs in the range of 0.8–12.2%. The homemade needles were applied for the extraction of pesticides in surface and ground aqueous samples collected from an agricultural area. Several target pesticides were identified and quantified in the investigated water samples.