The long-term release of uranium from residual sources at former uranium mill sites was often not considered in prior conceptual and numerical models, as contaminant removal focused on meeting radiological standards. To determine the reactive transport parameters, column tests were completed with various influent waters (deionized water, site groundwater, and local river water) on sediment from identified areas with elevated uranium on the solid phase in (1) vadose-zone (VZ) sediments, (2) saturated-zone sediments with higher organic carbon content, and (3) both vadose- and saturated-zone sediments with additional gypsum content. The gypsum was precipitated when low-pH, high-sulfate, tailings fluids or acidic waste disposal water were buffered by natural aquifer calcite dissolution. In general, the resulting uranium release was higher in the sediments with greater uranium concentrations. However, the addition of deionized water (DI) to the VZ sediments delayed the uranium release until higher-alkalinity groundwater was added. Higher-alkalinity river water continued to remove uranium from the VZ sediments for an extended number of pore volumes, with the uranium being above typical standards. Thus, river flooding is more efficient at removing uranium from VZ sediments than precipitation events (DI water in column tests). Organic carbon provides a stronger uranium sorption surface, which can be explained with geochemical modeling or a larger constant sorption coefficient (Kd). Without organic carbon, the typical sorption in sands and gravels is easily measurable, but sorption is stronger at lower, water-phase uranium concentrations. This effect can be simulated with geochemical modeling, but not with a constant Kd. Areas with gypsum create situations in which geochemical sorption is more difficult to simulate, which is likely due to the presence of uranium within mineral coatings. All the above mechanisms for uranium release must be considered when evaluating remedial strategies. Column testing provides initial input parameters that can be used in future reactive transport modeling to evaluate long-term uranium release rates and concentrations.
The U.S. Department of Energy Office of Legacy Management is responsible for the long-term care and maintenance of former uranium mill sites in the United States. Prior predictions of site flushing times (monitored natural attenuation) are not being met due to the presence of secondary contaminant sources associated with uranium-rich sediments in the vadose zone and organic-rich sediments near the water table below and near former mill tailings (tailings have been moved to a separate disposal site). Updated sitewide modeling for future releases of contaminants (including uranium) from these secondary sources to the groundwater need appropriate input parameters. To test field techniques, two cross-hole tracer tests and one infiltration tracer test were completed at a former uranium mill site in Grand Junction, Colorado. Reactive transport modeling was completed to derive physical and geochemical parameters. The observed data from saturated zone cross-hole tracer testing was adequately simulated using PHT-USG (reactive transport model) and PEST++ (calibration routine) with reasonable estimates of hydraulic conductivity, dispersion, effective porosity, cation exchange, calcite saturation index, and uranium sorption potential. The use of multiple layering in one cross-hole model was able to capture hydraulic conductivity variations with depth, which produced a double hump in the tracer concentrations. Estimated parameter values were very similar to prior estimates from column testing and single-well push–pull testing, except for a lower uranium sorption potential in one cross-hole test. This difference is likely due to the larger scale of the cross-hole testing including pathways with a lower uranium sorption potential. The infiltration testing released constituents from the vadose zone that can contribute to ongoing groundwater contamination. Modeling simulated the immediate release of these constituents to the water table similar to downward displacement of the existing residual porewater. Delayed drainage of the infiltration water was more difficult to simulate. However, the overall contaminant release concentrations from the vadose-zone secondary sources and ongoing groundwater contamination are adequately simulated for current site purposes. Additional details on vadose-zone processes may be needed if various remedial fluids are evaluated.