For a particular printing ink and drop-on-demand piezoelectric inkjet printhead, piezoelectric voltage and temperature of the ink were varied to change the inkjet performance, and the jetting velocity of the inkjet was analyzed under various conditions. The ink was cooled by using a Peltier module, which was attached to the nozzle plate as a heat sink. The inkjet drops were captured by the shadowgraphic method using a high-speed camera. The positions and velocities of these drops were then estimated after image processing. The drop state was distinguished by dimensionless numbers, such as the Weber and Z numbers, to decide whether it was stable for ejection and printing. Increasing the piezoelectric voltage increased the ejection velocity but with an associated generation of satellite drops. Cooling the ink increased the viscosity, which in turn decreased the drop velocity while diminishing the satellite drops. Therefore, it was shown that the cooled ink enabled stabilized inkjet ejection.

Experimental and numerical analysis of the drop-on-demand inkjet was conducted to determine the jetting characteristics and meniscus motion under the control of the ink supply pressure. A single transparent nozzle inkjet head driven by a piezoelectric actuator was used to eject droplets. To control ink supply pressure, the pressure of the air in the reservoir was regulated by a dual valve pressure controller. The inkjet performance and the motion of the meniscus were evaluated by visualization and numerical simulation. A two-dimensional axisymmetric numerical simulation with the dynamic mesh method was performed to simulate the inkjet dynamics, including the actual deformation of the piezoelectric actuator. Numerical simulation showed good agreement with the experimental results of droplet velocity and volume with an accuracy of 87.1%. Both the experimental and simulation results showed that the drop volume and velocity were linearly proportional to the voltage change. For the specific voltages, an analysis of the effect of the ink supply pressure control was conducted. At the maximum negative pressure, −3 kPa, the average velocity reductions were 0.558 and 0.392 m/s in the experiment and simulation, respectively, which were 18.7 and 11.6% less than those of the uncontrolled case of 0 kPa. Therefore, the simulation environment capable of simulating the entire inkjet dynamics, including meniscus movement regarded to be successfully established. The average volume reductions were 18.7 and 6.97 pL for the experiment and simulation, respectively, which were 21.7 and 9.17% less than those of the uncontrolled case. In the results of the meniscus motion simulation, the damping of the residual vibration agreed well with the experimental results according to the ink supply pressure change. Reducing the ink supply pressure reduced the speed and volume, improved the damping of residual vibrations, and suppressed satellite drops. Decreasing ink supply pressure can be expected to improve the stability and productivity of inkjet printing.