The widespread cork oak (Quercus suber L.) mortality and reduced afforestation /regeneration are causing an overall reduction in cork production. To enhance trees’ growth and vitality, afforestation techniques using fertirrigation were tested. The main objective was the promotion of trees’ growth on new dense plantations using minimum water requirements until reaching productive forests. The experimental plot – Irricork – was installed in 2017 in a ≈1 ha stand with 14 years’ age cork oaks summer-fertirrigated since plantation. Four fertirrigation treatments were applied during fertirrigation campaigns. Radial growth, meteorological parameters and fertirrigation volume were measured every 15–30 days over four years. It was observed that weather, tree size, debarking and trees’ intra-competition had a significant effect on radial increments. Fertirrigation significantly enhanced growth during summer drought and decoupled increments from air vapor pressure deficit constraints. There was a linear relationship between trees’ radial increments and fertirrigation volume up to 140 m3 week–1. Above this value, increments were smoother. In conclusion, summer fertirrigation of 140 m3 week–1 efficiently enhanced the radial growth of trees with 50–75 circumference at breast height, under the particular edaphoclimatic conditions of the stand. This study showed to be, therefore, promising in the use of efficient fertirrigation the enhance cork oaks’ radial growth.

Cork oak ( Quercus suber L.) grows in the Mediterranean basis including Portugal and is the main species producing cork which is used prevailingly in stopper industry. In our paper, cork from Quercus suber L. over three consecutive harvests from a traditional rainfed plot, between 1999 and 2017, and cork from an irrigated plot, harvested in 2017, were studied. We applied two X–ray image analysis technologies – X–ray micro-computed tomography and X–ray microdensitometry. Cork development, related with intern porosity, growth and density was studied with the objective of understanding the cork characteristics evolution over the years and with a different water regime. The outcomes of this study suggested an increase in density and porosity over harvests and a slight decrease of the cork growth. Cork samples from the irrigated plot, compared with cork from the same year of extraction in the rainfed plot, showed higher growth rate and higher porosity. The results demonstrated the contribution of climatic factor of precipitation as well as the silviculture model in cork characteristics, showing the relevance of the present work for the definition of the management practices. These may be determinant for enhancing cork quality and quantity production through silviculture measures. Our findings can be particularly useful for stakeholders especially under the conditions of Portugal in terms of increasing the value of the industrial chain of cork.

The bark of cork oak (Quercus suber L.) is mostly used for cork stopper production; when bark undergoes a series of industrial procedures, boiling usually leads to changes in the characteristics of its tissue. Trees are traditionally grown under natural conditions; however, irrigation is now being used in plantations. This permanent water availability affects cork oak development, while its effects on industrial procedures are unknown. This study provides the first insight into the behaviour of the cell walls of cork during the process of swelling and boiling when trees have been grown under irrigation, that is, subject to a specific water regime. Cork tissue is analysed using environmental and scanning electron microscopy under three regimes: raw conditions, following immersion in water, and after boiling. Additionally, the radial expansion of samples is determined. The results show greater cell wall expansion in cork from the irrigated site than in cork from the traditional rainfed plot when hydrated for 24 h. After boiling, the cell walls of the cork from the rainfed site are thinner than in the raw stage, which is in contrast to the irrigated cork. This study suggests that irrigation during cork oak growth produces a higher capacity for adsorption, increasing cell wall thickness from the raw stage to the boiling stage.

This study investigates the effect of the spatial distribution of soil water and nutrients on cork oak (Quercus suber) architecture. Fertirrigation is being tested in cork oak plantations to accelerate tree growth up to the production stage. To assess the impact of wet bulb location on tree development, six trees (three subjected to subsurface drip irrigation and three controls) were fully excavated at a sandy soil site, along with a seventh tree subjected to surface drip irrigation at a sandy loam soil site. The aerial parts of the trees were digitized using a Polhemus Fastrak magnetic digitizer and segmented into orders starting from the main trunk. Roots with diameters greater than 0.5 cm were digitized during excavation and segmented by size and order from the root collar. For each segment, length, orientation, and spatial location were calculated. General linear models were then applied to compare total root length across orientation and quadrant classes. Crown architecture was influenced by factors such as light competition. Irrigation treatments did not significantly affect root architecture when wet bulb formation was constrained. However, tree no. 7 had 50% of its total root length located within the wet bulb quadrant. These findings suggest that differences in soil type and irrigation method influence wet bulb formation, potentially reducing the impact of fertirrigation on root architecture. Strategies to minimize tree dependence on wet bulb zones are crucial for enabling future irrigation suppression.

The bark of cork oak (Quercus suber L.) is mostly used for cork stopper production, whereas bark is undergoing a series of industrial procedures, boiling usually leading to changes in the characteristics of the tissue. Trees are traditionally grown under natural conditions; however, irrigation is now being used in plantations. These permanent water availability affects cork-oak development, while its effects on industrial procedures is unknown. This study provides a first insight into the behaviour of the cell walls of cork during the process of swelling and boiling when trees have been grown under irrigation, subject to a specific water regime. Cork tissue was analysed using environmental and scanning electron microscopy under three regimes: raw conditions; following immersion in water; and after boiling. Additionally, the radial expansion of samples was determined. The results showed greater cell-wall expansion in cork from the irrigated site than cork from the traditional rainfed plot, when hydrated for 24h. After boiling, the cell walls of the rainfed site were thinner than in the raw stage, in contrast to the irrigated cork. This study suggests that irrigation during cork-oak growth produces a higher capacity for adsorption, increasing cell-wall thickness from the raw stage to the boiling stage.