BaY2F8 nanoparticles (NPs), doped with Yb3+ and Er3+ ions, were successfully produced by high-energy ball-milling. High-quality monoclinic single crystals (sp. gr. C2/m, a = 0.6969(3), b = 1.0502(1), c = 0.4254(1) nm, β = 99.676°) grown from the melt by the Bridgman technique were used as raw materials. The prepared nanocrystals were comprehensively studied by X-ray diffraction analysis, transmission electron microscopy, and optical spectroscopy. The fabrication possibility of single-phase irregular shaped Ba(Y0.964Yb0.030Er0.006)2F8 NPs in the size range of 20–100 nm with a milling duration of 10 h at 600 rpm is demonstrated. Ba(Y0.964Yb0.030Er0.006)2F8 NPs show intense luminescence by both up- (λ = 540 and 650 nm) and down-conversion (λ = 1540 nm) mechanisms upon IR excitation (λ = 980 nm). A qualitative comparison of the spectroscopic characteristics of the produced Ba(Y0.964Yb0.030Er0.006)2F8 NPs with the initial bulk crystal and the widely used up-conversion β-Na1.5(Y1.17Yb0.3Er0.03)F6 NPs is presented. Experimental data offer great opportunities of the Ba(Y0.964Yb0.030Er0.006)2F8 NPs applications in nanophotonics and biotechnology. High-energy ball-milling has potential as a versatile method for the scalable production of fluoride nanoparticles.
An optimized scalable production of single-phase rare-earth doped β-NaYF 4 nanoparticles is developed by the high-energy ball milling. This approach opens up prospects for the photoluminescent nanomaterials fabrication for biotechnology and photonics.
LiRF4 (R = Y, Yb, Lu) nanoparticles (NPs), co-doped by Yb3+/Er3+ and Yb3+/Tm3+ ions, have been synthesized by high-temperature coprecipitation method. The influence of the molar ratio of precursors and the cation composition of matrices on the sizes and morphology of particles is investigated. The method of heterogeneous crystallization of these compounds using LiYF4 nanoseeds is optimized, which opens opportunities to controlled synthesis of LiRF4 NPs with required characteristics. Among the objects studied, LiYF4@LiYbF4:Tm3+@LiYF4 NPs demonstrate the most intense anti-Stokes photoluminescence in the UV (λ = 362 nm) and blue (λ = 450 nm) ranges, which exceeds the corresponding characteristics for β-NaYF4:Yb3+/Tm3+@NaYF4 particles. LiYF4@LiLuF4:Yb3+/Er3+@LiYF4 NPs are the most efficient IR converters in the (λ = 1530 nm) among the investigated isostructural matrices; their spectral-luminescence characteristics are close to those of the β-NaYF4:Yb3+/Er3+@NaYF4 compound with the equivalent degree of codoping. The results obtained give possibilities to consider LiYF4@LiYbF4:Tm3+@LiYF4 and LiYF4@LiLuF4:Yb3+/Er3+@LiYF4 NPs as a real alternative to the most widely used phosphors based on hexa-gonal β-NaYF4 host for photonics and biotechnology applications.
The temperature changes in the crystal lattice parameters a (T) of cadmium and strontium difluorides, as well as their mutual solid solutions Сd1-xSrxF2 (x = 0.23, 0.50), were studied experimentally at temperatures of 5-300 K. The temperature dependences of the unit cell volume of the fluorides studied were analyzed in the Debye-Einstein model . An increased effect of the anharmonism of lattice vibrations of solutions due to the disorder of the crystal structure on their thermal properties is established. The model parameters and characteristics of the anharmonic contribution are determined. Based on the data obtained, the concentration dependence of the thermal conductivity of Сd1-xSrxF2 solid solutions at T = 300 K was calculated in the Calaway model, compared with published experimental data. The possibility of assessing the thermal conductivity of single crystals of solid solutions of the studied system on the basis of data on the thermal properties of solution components obtained on powder samples is shown.