Auxetic materials, possessing negative Poisson’s ratios (NPRs), have the ability to shrink (or expand) in the lateral direction under an axial compressive (or tensile) force respectively. Due to this unique feature, an auxetic material is found to sustain high energy absorption capacity, fracture toughness and shear resistance and thus regarded as one of the future materials in the field of impact protection. However, civil engineering applications of auxetic structures or materials are minimal due to miscellaneous restrictions on NPR effects. Accumulative developments in auxetics have facilitated their applications in cementitious materials in recent years. This paper presents an overview of recent advances in the development of auxetic cementitious composites and analyses and summarises their mechanical properties under different loading conditions. Prior to extensive finite element simulations, more attention has been given to the limited experimental results. Particular attention is paid to the expansionary feasibility of the parent material to introduce auxetic behaviour, with precise identification of the limitations, innovative composition methods and facilitation of auxetic features. Finally, the paper outlines the limitations of the current research and envisages few future research opportunities in auxetic cementitious composites.
Prefabrication has been shown to be an effective way of construction in the modern-day context. Although much progress has been made in developing reinforced concrete (RC), timber and steel prefabricated elements/structures, prefabrication of masonry walling systems has received limited attention in the past. Conventional masonry construction is labour-intensive and time-consuming; therefore, prefabrication can be an effective solution to accelerate the masonry construction to make it more cost-effective. Therefore, in this paper, an attempt has been made to evaluate the effectiveness of prefabricated masonry systems (PMS) in terms of their structural characteristics and sustainability perspectives in an Australian context. Subsequently, the available studies related to PMS and the prospects of developing prefabricated masonry walling systems were appraised and reported. In order to assess the applicability of PMS, a case study was carried out by designing four types of prospective prefabricated masonry walling systems for a typical housing unit in Australia. It was shown that the reinforced (RM), post-tensioned (PT) and thin layered mortared (TLM) masonry systems are better suited for prefabrication. Later, in order to assess the sustainability of the considered masonry walling systems, life cycle energy analyses were carried using the Environmental Performance in Construction (EPIC) database. It was found that there can be nearly 30% and 15% savings, respectively, in terms of energy saving and CO2 emissions in prefabricated construction than the conventional masonry construction. Finally, the prospects of developing PMS and the need for future research studies on these systems are highlighted.
3D printed auxetic metamaterials can be used to make high performing cementitious composites to strengthen existing structures and elements due to their negative Poisson’s ratio behaviour and high energy absorbing characteristics. In this paper, three different re-entrant chiral auxetic (RCA) meshes of various cell geometries and orientations were developed by 3D printing them using poly-lactic acid (PLA) and thermoplastic polyurethane (TPU) filament. The developed meshes were tested under out-of-plane flexure to study their load carrying capacity, ductility and energy absorption characteristics, especially to characterise the best cell orientation. The horizontal cells provided enhanced load carrying and energy absorption characteristics for all three cell geometries for both materials. These RCA meshes were then embedded into low and high strength premix cement mortar matrices to develop auxetic cementitious composites (ACCs). In total, 42 ACC specimens were casted and tested under flexural loading. The results were studied in terms of their failure patterns, load-displacement responses, flexural capacities, ductility and energy absorption. The RCA meshes made of PLA filament showed limited capacity and energy absorption as compared to RCA meshes made of TPU filament due to extended flexibility and resilience provided by TPU meshes. The RCA meshes with a denser cell structure exhibited highest flexural capacity and effective energy absorption of 14 700 kJ m−2 for TPU-RCA mesh embedded into high strength cement mortar matrix. The results obtained in this study have enabled to understand the flexural behaviour of cementitious composites embedded with 3D printed auxetic lattices and to strengthen the existing structures.
21 January 2023 in Journal of Building Engineering