Change in the mechanism of post corrosion bond behavior was investigated in a previous experimental study by analyzing the deformations in concrete using digital image correlation (DIC). Using their DIC data, this study focuses on the local strain non-uniformity in reinforcing bar during the uniaxial tensile test due to the effect of rib height reduction and corrosion layer. The results show that, the local strain below the rib tip is higher than that below the flat part between ribs, due to compressive stress resulting from mechanical interaction at the rib tip. Furthermore, the non-uniformity in local strain is less pronounced in highly corroded reinforcing bar because less compressive stress is transferred due to gentler rib slope. In highly corroded reinforcing bar, the appearance of non-uniformity in local strain is delayed since the accumulated corrosion product on the reinforcing bar surface delays the mechanical interaction and stress transfer between the concrete and the reinforcing bar.
The buildup of corrosion products over a reinforcing bar and associated reduction in rib height lead to degradation of the bond between reinforcement and concrete. The authors have previously used digital image correlation (DIC) to visualize and quantify load-induced cracking at the interface in specimens with varying degrees of corrosion. The results obtained in that study are used here to simulate the post-corrosion local bond behavior. A bond degradation model is incorporated into the discrete analysis tool, 3D Rigid Body Spring Model (RBSM) for the simulation. This analysis method allows the shape of the reinforcing bar to be directly modeled, and concrete cracking behavior is simulated by using a randomly shaped mesh. The magnitude of opening and sliding over the tips of ribs in the simulation, in which the reduction in rib height could not be modeled, is significantly lower than observed in the experiment. The results demonstrate that reduction in rib height is an important factor in post-corrosion behavior, and needs to be included in simulation models. It is also understood that in order to gain a better understanding of local post-corrosion bond behavior, de-bonding between reinforcement and concrete needs to be modeled in a discrete analysis framework.