Square mesh panels (SMPs) are selective devices used extensively to supplement codend size selectivity in trawl fisheries. Therefore, predictions of the effect of mesh size in both SMPs and codends on size selectivity are valuable. Here, we established a framework to predict the size selection of blue whiting through different SMPs and diamond mesh codends based on the morphological characteristics of this species. We hypothesized that size selection for an SMP is determined by different fish contact angles, whereas different mesh opening angles determine size selection for the codend. Based on these hypotheses, we first developed a model that enabled us to predict which sizes of blue whiting are able to pass through meshes of different sizes and shapes. We then tested whether the selectivity for blue whiting of the SMP, the codend, and the combination of both could be explained by the models. Finally, we predicted the size selectivity of multiple combinations of SMPs and diamond mesh codends. The method presented here can potentially be applied to make predictions for species other than blue whiting.
Reduction of discards from the Basque mixed bottom trawl fishery is a challenge. To improve the selective properties of the gear used by the fleet and supplement codend size selection, a square mesh panel (SMP) installed in the upper panel of the trawl was introduced in 2006. However, recent studies have shown that the release efficiency of this SMP is low due to lack of contact between the fish and the SMP. In this study, we tested the release efficiency of the SMP for four different gear configurations. We tested the effect of adding LED lights at two different positions and altering panel size and panel position in the trawl. The analyses were focused on two species: hake (Merluccius merluccius) and blue whiting (Micromesistius poutassou). The results showed that the position of LED lights did not significantly affect the SMP’s release efficiency for any species. However, increasing panel size had a significant positive effect on the release efficiency of blue whiting, and placing the SMP in the lower panel improved the release efficiency of hake. These results highlight the challenge of simultaneously improving the selective properties of gear for species with different behaviour, especially in mixed demersal fisheries.
Gear modifications in fisheries are usually implemented to obtain catch patterns that meet management objectives. In the Basque bottom trawl fishery, gear regulations include the use of a square mesh panel (SMP) placed at the top panel of the extension piece of the trawl to supplement diamond mesh codend selectivity. However, the catch patterns obtained with this combination have raised concern among scientists and authorities. This study combines new data on different SMP and codend designs with existing data from the literature to produce new results that are applied to predict the size selectivity and catch patterns of different gear combinations for a variety of fishing scenarios. A systematic approach based on the concept of treatment trees was outlined and applied to depict the effect of individual and combined gear design changes on size selectivity and catch patterns for hake (Merluccius merluccius) and blue whiting (Micromesistius poutassou). This approach led to identification of the gear combination with the most appropriate exploitation pattern for these two species and improved the readability and interpretation of selectivity results. The results demonstrated that changes both in SMP and, especially, codend designs have a significant effect on hake and blue whiting size selectivity and catch patterns. Therefore, we believe that further research should prioritize codend size selectivity, and additional selection devices may be added once codend designs with good selective properties are achieved.
Diamond meshes in trawl codends have limited openness, which reduces escape opportunities for roundfish. Shortening the lastridge ropes (LR) attached to codend selvedges can increase the availability of open meshes resulting in higher chances of escape. However, this availability does not imply optimal mesh openness, nor does it guarantee use. We estimate the escape probability of hake, horse mackerel and blue whiting through a 20% shortened LR codend and a standard codend, and quantify the contribution of different mesh opening angles (OAs) to their size selectivity. The results confirm that high OAs increase escape opportunities for all species. However, shortened LR only improved size selectivity significantly for horse mackerel and blue whiting. This difference between species may be related to behavioural differences. The mesh openness achieved with 20% shortened LR was below that necessary to obtain optimal escape opportunities for these species. The study highlights the relevance of considering fish morphology and behaviour to optimally exploit size selectivity when designing shortened LR codends.
Gear modifications in fisheries are usually implemented to obtain catch patterns that meet management objectives. In the Basque bottom trawl fishery, gear regulations include the use of a square mesh panel (SMP) placed at the top panel of the extension piece of the trawl to supplement diamond mesh codend selectivity. However, the catch patterns obtained with this combination have raised concern among scientists and authorities. This study combines new data on different SMP and codend designs with existing data from the literature to produce new results that are applied to predict the size selectivity and catch patterns of different gear combinations for a variety of fishing scenarios. A systematic approach based on the concept of treatment trees was outlined and applied to depict the effect of individual and combined gear design changes on size selectivity and catch patterns for hake (Merluccius merluccius) and blue whiting (Micromesistius poutassou). This approach led to identification of the gear combination with the most appropriate exploitation pattern for these two species and improved the readability and interpretation of selectivity results. The results demonstrated that changes both in SMP and, especially, codend designs have a significant effect on hake and blue whiting size selectivity and catch patterns. We believe the results obtained provide new insight about the potential of gear modification to improve exploitation patterns in trawl fisheries and illustrate the suitability of the methodology used to explore more sustainable gear designs.