Practical techniques to identify heat routes at the nanoscale are required for the thermal control of microelectronic, thermoelectric, and photonic devices. Nanoscale thermometry using various approaches has been extensively investigated, yet a reliable method has not been finalized. We developed an original technique using thermal waves induced by a pulsed convergent electron beam in a scanning transmission electron microscopy (STEM) mode at room temperature. By quantifying the relative phase delay at each irradiated position, we demonstrate the heat transport within various samples with a spatial resolution of ~10 nm and a temperature resolution of 0.01 K. Phonon-surface scatterings were quantitatively confirmed due to the suppression of thermal diffusivity. The phonon-grain boundary scatterings and ballistic phonon transport near the pulsed convergent electron beam were also visualized.
31 March 2025 in Journal of Colloid and Interface Science
Alongiside the growing demand for wearable and implantable electronics, the development of flexible thermoelectric (FTE) materials holds great promise and has recently become a highly necessitated and efficient method for converting heat to electricity. Conductive polymers were widely used in previous research; however, n-type polymers suffer from instability compared to the p-type polymers, which results in a deficiency in the n-type TE leg for FTE devices. The development of the n-type FTE is still at a relatively early stage with limited applicable materials, insufficient conversion efficiency, and issues such as an undesirably high cost or toxic element consumption. In this work, as a prototype, a flexible n-type rare-earth free skutterudite (CoSb3)/poly(3,4-ethylenedioxythiophene)-polystyrene sulfonate (PEDOT:PSS) binary thermoelectric film was fabricated based on ball-milled skutterudite via a facile top-down method, which is promising to be widely applicable to the hybridization of conventional bulk TE materials. The polymers bridge the separated thermoelectric particles and provide a conducting pathway for carriers, leading to an enhancement in electrical conductivity and a competitive Seebeck coefficient. The current work proposes a rational design towards FTE devices and provides a perspective for the exploration of conventional thermoelectric materials for wearable electronics.
Loading cocatalysts on semiconductor-based photocatalysts to create active reaction sites is a preferable method to enhance photocatalytic activity and a widely adopted strategy to achieve effective photocatalytic applications. Although theoretical calculations suggest that the broad density of states of noble metal cocatalysts, such as Pt, act as a recombination center, this has never been experimentally demonstrated. Herein, we employed pico–nano and nano–micro second transient absorption spectroscopy to investigate the often overlooked photogenerated holes, instead of the widely studied electrons on Pt- and Ni-loaded SrTiO3 to evaluate the effects of cocatalysts as a recombination center. It is demonstrated that Pt serves as the recombination center with no sacrificial agent; recombination can be suppressed by a hole scavenger, while recombination is not significant on Ni with localized density of states. It is also found that photo-generated holes in SrTiO3 tend to migrate to Pt within 400 ps, and photo-generated holes generated in the bulk gradually migrate to Pt cocatalysts in a micro-second regime.