Nowadays, thanks to the enhancement in computational power and software development, advanced mathematical modelling based on computational fluid dynamics (CFD) allows us to represent almost any system. Anaerobic bioreactors correspond to a complex biosystem where multiple reactions, in parallel and/or in series, take place. Besides this biological complexity, the actual digester operation increases the system's complexity given the number of transport phenomena that also occur; therefore, few real applications may be found in which mathematical models are properly harnessed. This review presents a general assessment of the CFD applications that have been applied in anaerobic digestion processes starting with the model set-up up to the post-processing of the results. In regards to the model pre-processing and setup, the generation and evaluation of the mesh and the model specifications such as multiphase flow, turbulence regimen, rheology characterization and impeller motion, are addressed. Due to the importance of the evaluation of the model's outcome, topics such as error assessment and origin, model calibration and validation are discussed. The current challenges and future perspectives of this type of mathematical modeling are also addressed, with particular emphasis on the integration of biological reactions with the conventional fluid dynamic modeling.
Modelling in anaerobic digestion will play a crucial role as a tool for smart monitoring and supervision of the process performance and stability. By far, the Anaerobic Digestion Model No. 1 (ADM1) has been the most recognized and exploited model to represent this process. This study aims to propose simple extensions for the ADM1 model to tackle some overlooked operational and metabolic aspects. Extensions for the discontinuous feeding process, the reduction of the active working volume, the transport of the soluble compound from the bulk to the cell interior, and biomass acclimation are presented in this study. The model extensions are included by a change in the mass balance of the process in batch and continuous operation, the incorporation of a transfer equation governed by the gradient between the extra- and intra- cellular concentration, and a saturation-type function where the time has an explicit influence on the kinetic parameters, respectively. By adding minimal complexity to the existing ADM1, the incorporation of these phenomena may help to understand some underlying process issues that remain unexplained by the current model structure, broadening the scope of the model for control and monitoring industrial applications.
Anaerobic mono-digestion and co-digestion are nowadays widely used in wastewater treatment plants (WWTP). However, the data processing of the conventional biochemical potential test (BMP) carried out to assess potential substrates should be enhanced to reduce the uncertainty of the results. In this study, two methodologies aiming to improve the data processing in anaerobic digestion studies were proposed. The methodologies aimed at the estimation of synergy in anaerobic co-digestion of organic waste and the standardization of the BMP test results by considering the activity of the inoculums under mono-digestion conditions. Both methodologies comprise the application of the Gompertz equation. For the first methodology, four cosubstrates and two types of substrates were used. Regarding synergy estimation, the cosubstrates dairy whey and grease sludge had an impact on the degradation kinetic. In regard to the second methodology, the results indicate that the activity of the inoculums exerts an influence on the BMP analysis, and it should be considered. This can be meaningful when comparing results among studies when different inoculums are used or even for studies where the same inoculum is used but it is taken at different reactor operational moments.
During mathematical representation of microbial cultures, it is normally assumed that changes in the environment produce instantaneous effects on growth. However, reports are available indicating that sometimes this may not be the case. This work studied the existence of delays on the response of a population of microalgae when subjected to changes in energy and carbon sources, and when exposed to a growth inhibitor. Results show that no appreciable delays exist when microalgae undergo changes in the incident light intensity. For changes in carbon source concentration (inorganic carbon), a small delay in the range of minutes was detected. Finally, when exposing microalgae to inhibitory concentrations of ammonia, a significant delay of several hours was observed.
Microaeration can be used to cost-effectively remove in-situ H2S from the biogas generated in anaerobic digesters. This study is aimed at developing and validating an extension of the Anaerobic Digestion Model n°1 capable of incorporating the main phenomena which occurs during microaeration. This innovative model was implemented and tested with data from a pilot scale digester microaerated for ∼ 200 d. The results showed that despite the model's initial ability to predict the digester's behavior, its predicted performance was improved by calibrating the most influential parameters. The model's prediction potential was largely enhanced by adding retention parameters that account for the activity of sulfide oxidizing bacteria retained inside the anaerobic digester, which have been consistently shown to be responsible for a large share of the H2S removed.