Surrounding rock deformation control of gob-side coal-rock roadway in inclined coal seams (GCRICS) is a major problem in gob-side entry technology application practice. This paper describes a case study of the surrounding rock deformation characteristics and control technology of a typical GCRICS in Guizhou, China. As according to data obtained during a field investigation, the reasons for the deformation and failure of 151509 tailentry and the shortcomings of the original support scheme were analyzed. In combination with existing theory and field experience, the “anchor cable + U-shaped steel + shotcreting + grouting” (CUSG) support method was proposed. The plastic zone distribution, displacement, and stress evolution law of the roadway-surrounding rock under the four support modes were analyzed and compared by numerical simulation. The results show that the supporting effects of several support methods varied from good to poor; CUSG was the best, followed by anchor cable support, U-shaped steel support, and then no support. Based on the previous seepage grouting theory, a slurry diffusion model of hollow grouted anchor cable (HGC) was established and the calculation formulas of slurry diffusion radius and grouting time were deduced, which provided guidance for field construction. Finally, the CUSG surrounding rock control technology was applied to 151509 tailentry subsequent roadway support. Through drill holes, analysis of the surrounding rock of the non-grouting area and the grouting area was conducted. It was found that the surrounding rock of the grouting area was high in integrity and strong in bearing capacity. Throughout the excavation period to the end of roadway mining, the roadway did not have to be repaired. This case study has high practicability, high popularization value, and provides a useful reference for the engineering support design of the GCRICS.

In order to reveal the influence of the pull-out rate on the load-bearing properties of the coal–rock combined anchor body, the mechanical properties and failure characteristics of a coal–rock combined anchor body under different pull-out rates (10, 20, 30, 40, 50 mm/min) were studied using the pull-out test and theoretical analysis. The results show that the bearing capacity of the bolt on the coal–rock combined anchor body improves under a dynamic load, but the load-bearing properties of the coal–rock combined anchor body are different from those of the full rock (coal) anchor body. With the increase in the pull-out rate, the maximum pull-out load of the bolt on the coal–rock combined anchor body increases first, then decreases, and finally tends to be stable. Under the condition of a low drawing rate, the bearing capacity of the coal–rock combined anchor system can be greatly improved, but when the pull-out rate exceeds 20 mm/min, the bearing capacity of the anchor system is reduced. The debonding process of the anchoring section of the coal–rock combined anchor body gradually expands from the beginning section of the anchor to the bottom of the borehole. The coal–rock combined anchor body undergoes time differential development of cracks, and the failure of the coal and rock mass occurs at different times. Its failure process can be divided into three stages: (1) the coal anchor and rock anchor act together; (2) the rock anchor acts alone; and (3) the coal anchor and rock anchor have residual action.