Jongkil Lee

Prof. Dr. Jongkil Lee


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 April 2022 in Micromachines
Verified
Journal Article
Open access
PDF file
JLJongkil Lee
Jongkil Lee
JAJinhyo Ahn
Jinhyo Ahn
HJHyundu Jin
Hyundu Jin
CLChong Hyun Lee
Chong Hyun Lee
YJYoonSang Jeong
YoonSang Jeong
YCYohan Cho
Yohan Cho
For the purpose of stably supplying electric power to the underwater wireless sensor, the energy harvesting technology in which a voltage is obtained by generating displacement in a piezoelectric material using flow-induced vibration is one of the most attractive research fields. The funnel type energy harvester (FTEH) with PVDF proposed in this study is an energy harvester in which the inlet has a larger cross-sectional area than the outlet and a spiral structure is inserted to generate a vortex flow at the inlet. Based on numerical analysis, when PVDF with L = 100 mm and t = 1 mm was used, the electric power of 39 μW was generated at flow velocity of 0.25 m/s. In experiment the average RMS voltage of FTEH increased by 0.0209 V when the flow velocity increased by 1 m/s. When measured at 0.25 m/s flow velocity for 25 s, it was shown that voltage doubler rectifier (VDR) generated a voltage of 133.4 mV, 2.25 times larger than that of full bridge rectifier (FBR), and the energy charged in the capacitor was 44.3 nJ, 14% higher in VDR than that of the FBR. In addition, the VDR can deliver power of 17.75 μW for 1 kΩ load. It is shown that if the voltage generated by the FTEH using the flow velocity is stored using the VDR electric circuit, it will greatly contribute to the stable power supply of the underwater wireless sensor.

23 December 2022 in Sensors
Verified
Journal Article
Open access
PDF file
KLKibae Lee
Kibae Lee
YJYoonSang Jeong
YoonSang Jeong
CLChong Hyun Lee
Chong Hyun Lee
JLJongkil Lee
Jongkil Lee
HSHee-Seon Seo
Hee-Seon Seo
YCYohan Cho
Yohan Cho
Polyvinylidene fluoride (PVDF) is an emerging method for energy harvesting by fluid motion with superior flexibility. However, the PVDF energy harvester, which has a high internal impedance and generates a low voltage, has a large power transmission loss. To overcome this problem, we propose an impedance-coupled voltage-boosting circuit (IC-VBC) that reduces the impedance of the PVDF energy harvester and boosts the voltage. SPICE simulation results show that IC-VBC reduces the impedance of the PVDF energy harvester from 4.3 MΩ to 320 kΩ and increases the output voltage by 2.52 times. We successfully charged lithium-ion batteries using the PVDF energy harvester and IC-VBC with low-speed wind power generation.

Verified
Journal Article
Open access
PDF file
KLKibae Lee
Kibae Lee
HYHyun Hee Yim
Hyun Hee Yim
YJYoonsang Jeong
Yoonsang Jeong
JLJongkil Lee
Jongkil Lee
CLChong Hyun Lee
Chong Hyun Lee
The Janus Helmholtz transducer (JHT) is known for high transmission voltage response (TVR) over a wide bandwidth by its dual-resonance characteristics. It is usually required to design matching circuits for wideband power transmission of JHT. However, conventional matching circuit designs can neither easily cover wide bandwidth nor deliver maximum active power to load. To address this limitation, we propose a novel impedance matching circuit design method to maximize overall power transfer efficiency. The method is based on objective functions of both input and load power factors. The proposed method achieves better active power transfer to load than methods using commonly used input power factor alone. To prove feasibility of the proposed method, we consider equivalent circuit models of cable and JHT and adopt a compact matching circuit of resonant components and a coupling capacitor. By considering three JHTs, two power driving systems, and two frequency bands, we show that the proposed method can achieve a significant improvement in active power transfer to load. By conducting experiments of equivalent JHT circuit, cable, and matching circuit, we also show that input power factor increases by 73.2%, while active power delivered to load increases by 2.03 mW with 1 Vrms input voltage.

10 January 2023 in Sensors
Verified
Journal Article
Open access
PDF file
JLJongkil Lee
Jongkil Lee
JAJinhyo An
Jinhyo An
CLChonghyun Lee
Chonghyun Lee
YJYoonSang Jeong
YoonSang Jeong
HSHee-Seon Seo
Hee-Seon Seo
YCYohan Cho
Yohan Cho
In this study, two thin rectangular PVDFs were installed in the form of a cantilever on a FTEH (funnel-type energy harvester), and a CTEH (cymbal-type energy harvester) was fabricated in a form coupled to the upper part of the support. As a result of measuring the energy harvesting sensitivity according to the installation direction of the CTEH, a high voltage was measured in the structure installed on top of the support across all flow velocity conditions. A composite structure PVDF energy harvester combining CTEH and FTEH was fabricated and the amount of power generated was measured. As a result of measuring the open-circuit voltage of the PVDF energy harvester device with a composite structure to which the optimum resistance of CTEH of 241 kΩ and the optimum resistance of FTEH of 1474 kΩ were applied at a flow rate of 0.25 m/s, the output voltage compared to the RMS average value was 7 to 8.5 times higher for FTEH than for CTEH. When the flow rate was 0.5 m/s, the electrical energy charged for 500 s was measured as 2.0 μWs to 2.5 μWs, and when the flow speed was 0.75 m/s, it reached 2.5 μWs when charged for 300 s, generating the same amount when the flow rate increased by 50%. The time to do it was reduced by 66.7%.