Synthetic 2D crystal films grown by chemical vapor deposition are typically polycrystalline, and determining grain size within domains and continuous films is crucial for determining their structure. Here we show that grain boundaries in the 2D transition metal dichalcogenide WS₂, grown by CVD, can be preferentially oxidized by controlled heating in air. Under our developed conditions, preferential degradation at the grain boundaries causes an increase in their physical size due to oxidation. This increase in size enables their clear and rapid identification using a standard optical microscope. We demonstrate that similar treatments in an Ar environment do no show this effect, confirming that oxidation is the main role in the structural change. Statistical analysis of grain boundary (GB) angles shows dominant mirror formation. Electrical biasing across the GB is shown to lead to changes at the GB and their observation under an optical microscope. Our approach enables high-throughput screening of as-synthesized WS₂ domains and continuous films to determine their crystallinity and should enable improvements in future CVD growth of these materials.

Additive manufacturing has provided a pathway for inexpensive and flexible manufacturing of specialized components and one-off parts. At the nanoscale, such techniques are less ubiquitous. Manufacturing at the nanoscale is dominated by lithography tools that are too expensive for small- and medium-sized enterprises (SMEs) to invest in. Additive nanomanufacturing (ANM) empowers smaller facilities to design, create, and manufacture on their own while providing a wider material selection and flexible design. This is especially important as nanomanufacturing thus far is largely constrained to 2-dimensional patterning techniques and being able to manufacture in 3-dimensions could open up new concepts. In this review, we outline the state-of-the-art within ANM technologies such as electrohydrodynamic jet printing, dip-pen lithography, direct laser writing, and several single particle placement methods such as optical tweezers and electrokinetic nanomanipulation. The ANM technologies are compared in terms of deposition speed, resolution, and material selection and finally the future prospects of ANM are discussed. This review is up-to-date until April 2014.

Large amounts of waste heat generated in our fossil-fuel based economy can be converted into useful electric power by using thermoelectric generators. However, the low-efficiency, scarcity, high-cost and poor production scalability of conventional thermoelectric materials are hindering their mass deployment. Nanoengineering has proven to be an excellent approach for enhancing thermoelectric properties of abundant and cheap materials such as silicon. Nevertheless, the implementation of these nanostructures is still a major challenge especially for covering the large areas required for massive waste heat recovery. Here we present a family of nano-enabled materials in the form of large-area paper-like fabrics made of nanotubes as a cost-effective and scalable solution for thermoelectric generation. A case study of a fabric of p-type silicon nanotubes was developed showing a five-fold improvement of the thermoelectric figure of merit. Outstanding power densities above 100 W/m ² at 700 °C are therefore demonstrated opening a market for waste heat recovery.

Growing monolayer MoS ₂ films that are continuous with large domain sizes by chemical vapor deposition is one of the major challenges in 2D materials research at the moment. Here, we explore how atmospheric pressure CVD can be used to grow centimeter scale continuous films of monolayer MoS ₂ films directly on Si substrates with an oxide layer whilst also obtaining large domain sizes exceeding 20 μ m within the films. This is achieved by orientating the growth substrate in a vertical position to improve the uniformity of precursor feed-stock compared to horizontally orientated growth substrates. This leads to continuous films of monolayer MoS ₂ over a significantly larger area without the need for low-pressure vacuum systems or volatile precursors. This provides important insights into novel approaches for maximizing domain sizes within MoS ₂ films, with concomitant large area uniform coverage.