In this paper, we perform an absolute equation of state (EOS) measurement on the principal Hugoniot of aluminum using a near-symmetric impact method. The flyer plates are accelerated to high velocities using the laser-ramp-driven method. An aluminum flyer plate of ~25 µm is accelerated to the velocity range from 4 to 12 km/s. Then the aluminum flyer plate propagates across a vacuum gap and impacts with an aluminum step target. A line-imaging optical recording velocity interferometer for any reflector (ORVIS) is used to measure the aluminum flyer plate and the shock velocity simultaneously. Aluminum EOS data were measured with pressures range from 50 to 200 GPa. This absolute EOS measurement method may be used for studying a variety of materials.
5 December 2011 in Measurement Science and Technology
The sound velocities of water in the Hugoniot states are investigated by laser shock compression of precompressed water in a diamond anvil cell. The obtained sound velocities in the off-Hugoniot region of liquid water at precompressed conditions are used to test the predictions of quantum molecular dynamics (QMD) simulations and the SESAME equation-of-state (EOS) library. It is found that the prediction of QMD simulations agrees with the experimental data while the prediction of SESAME EOS library underestimates the sound velocities probably due to its improper accounting for the ionization processes.
Direct-drive and indirect-drive inertial confinement fusion (ICF) targets use temporally shaped drive pulses to optimize target performance. The timing of multiple shock waves is crucial to the performance of ICF ignition targets. Velocity interferometer system for any reflector (VISAR) is the principal diagnostic tool for shock-timing experiments. We present velocity measurements from the shock waves in polystyrene targets driven by two 200-ps pulses separated by 1–2 ns. These pulses drive two shock waves that coalescence in the target. Coalescence time and transit times are observed by VISAR.
It is well known that initial defects play an essential role in the dynamic failure of materials. In practice, dynamic tension is often realized by release of compression waves. In this work, we consider void-included single-crystal aluminum and investigate the damage characteristics under different shock compression and release based on direct atomistic simulations. Elastic deformation, limited growth and closure of voids, and the typical spall and new nucleation of voids were all observed. In the case of elastic deformation, we observed the oscillatory change of void volume under multiple compression and tension. With the increase of impact velocity, the void volume reduced oscillations to the point of disappearance with apparent strain localization and local plastic deformation. The incomplete or complete collapsed void became the priority of damage growth under tension. An increase in sample length promoted the continuous growth of preset void and the occurrence of fracture. Of course, on the release of strong shock, homogeneous nucleation of voids covered the initial void, leading to a wider range of damaged zones. Finally, the effect of the preset void on the spall strength was presented for different shock pressures and strain rates.