Magnesium (Mg) and its alloys, which have good mechanical properties and damping capacities, are considered as potential candidate materials in the industrial field. Nevertheless, fast corrosion is the main obstacle that seriously hinders its wide applications. Surface modification is an available method to avoid the contact between corrosive media and Mg substrates, thus extending the service life of Mg-based materials. Generally, manufacturing a dense and stable coating as physical barriers can effectively inhibit the corrosion of Mg substrates; however, in some complex service environments, physical barrier coating only may not satisfy the long-term service of Mg alloys. In this case, it is very important to endow the coating with suitable functional characteristics, such as superhydrophobic and self-healing properties. In this review, the various surface treatments reported are presented first, followed by the methods employed for developing superhydrophobic surfaces with micro/nanostructuring, and an overview of the various advanced self-healing coatings, devolved on Mg alloys in the past decade, is further summarized. The corresponding preparation strategies and protection mechanisms of functional coatings are further discussed. A potential research direction is also briefly proposed to help guide functional strategies and inspire further innovations. It is hoped that the summary of this paper will be helpful to the surface modification of Mg alloys and promote the further development of this emerging research field.
In this study, an silver (Ag) plating with micro/nano-dendrite structures is prepared on the 304 stainless steel (SS304) surface by potentiostatic deposition (Ag/SS304). After being modified by n-dodecyl mercaptan (NDM) with the low surface energy, the obtained sample (NDM@Ag/SS304) exhibits stable superhydrophobicity and excellent hot-water repellency. The surface morphology and composition of NDM@Ag/SS304 are analyzed by scanning electron microscope (SEM), X-ray spectrometer (EDS), X-ray diffractometer (XRD), and X-ray photoelectron spectrometer (XPS) characterization. The electrochemical measurements, tests of water contact angle (WCA), and interfacial contact resistance (ICR) are employed to systematically study the performance of the NDM@Ag/SS304 in the simulated cathode environment of proton exchange membrane fuel cell (PEMFC). The results show that the NDM@Ag/SS304 has high corrosion potential (~0.25 V) and low corrosion current density (~4.04 μA/cm2); after potentiostatic polarization (0.6 V, 5 h), the NDM@Ag/SS304 also shows high superhydrophobic stability.
Welding copper (Cu) and aluminum (Al) is highly demanded for lightweight and cost-effective manufacturing. However, it faces significant challenges. First, substantial differences in physical properties may lead to high residual stresses and distortion. Second, brittle intermetallic compounds (IMCs) readily form at the interface, severely compromising the joint’s mechanical properties and electrical conductivity. Third, the native oxide film on Al impedes effective wetting and bonding. Therefore, effective control over the interfacial microstructure of the welded joint is essential. This review provides a critical analysis and comparison of several typical welding techniques, including laser welding (LW), friction stir welding (FSW), ultrasonic welding (UW), brazing and soldering, and welding–brazing. These analyses focus on their process characteristics, joint microstructures, and corresponding formation mechanisms. Furthermore, this review synthesizes key strategies for enhancing joint quality, including process parameter optimization, introduction of functional interlayers, and external assistance, aimed at optimizing joint microstructure and minimizing defects. Based on the analysis, this work provides comparative insights into process selection and microstructure control, and highlights future directions: advancing novel methods such as magnetic pulse welding and transient liquid phase bonding; developing intelligent real-time process control to suppress brittle IMCs and associated defects; promoting sustainable practices and establishing standardized performance evaluation; and systematically investigating long-term reliability to support the industrial application of robust Cu/Al joints.